If you mean 2/0 copper wire it is rated 175 amps. # 2 wire is 115 amps. If you are referring to 2.0 metric it is rated 15 amps.
Wiki User
∙ 10y agoAluminum 4/0 wire car carry 180 amps at at 75 degrees Fahrenheit or 205 amps at 90 degrees. .
3/0 gauge
At the service entrance you will need AWG 1/0 gauge.
As a service entrance wire you need AWG # 3/0 gauge copper.
There are two distinct questions here. To determine the wire size to carry 15000 volts the circuits load amperage must be stated. The wire size for a 550 amp service is, an 800 MCM copper conductor with an insulation factor of 90 degrees C. This conductor is rated at 555 amps. Parallel 250 MCM will give you a total capacity of 580 amps. A triple run of 2/0 will give you a total capacity of 585 amps.
Aluminum 4/0 wire car carry 180 amps at at 75 degrees Fahrenheit or 205 amps at 90 degrees. .
3/0 gauge
A zero gauge wire can typically handle up to 300 amps of current. However, the exact capacity may vary depending on the specific wire material and insulation used in the wire. It is important to consult the manufacturer's specifications for the wire you are using to determine the exact ampacity.
Each hot leg to the neutral wire of the service has the ampacity of 200 amps, that is why 3/0 wire is required. A 3/0 copper wire with an insulation factor of 90 degrees C is rated at 210 amps.
At the service entrance you will need AWG 1/0 gauge.
3/0 wire 3/0 wire
The maximum amperage of a 0 gauge wire typically ranges from 150 to 200 amps for automotive applications. However, it is important to consult the specific manufacturer's guidelines and consider factors such as temperature and installation conditions to ensure the safe use of the wire.
A 4/0 copper wire can typically carry about 230-260 amps of current. The actual ampacity can vary depending on factors such as installation method, temperature, and insulation type. It is important to consult the National Electrical Code (NEC) or a licensed electrician for specific ampacity ratings.
Service wire required is AWG # 3/0 copper.
The maximum ampacity for 4/0 copper wire is approximately 230 amps when used in a building or residential wiring application. This rating may vary depending on the specific insulation type and local electrical codes, so it's always best to consult with a qualified electrician for accurate information.
The size of wire needed for a 220v circuit depends on the amperage of the circuit. For a typical 220v circuit at residential settings, a 10-gauge wire size is commonly used for 30 amps, while larger circuits may require 8 or 6-gauge wire for higher amperage ratings. It is important to consult with a licensed electrician to ensure the correct wire size is used for your specific application.
As a service entrance wire you need AWG # 3/0 gauge copper.