It will power two 400 watt lamps.
No, the ballast has to be matched to the lamp. 250 watt ballast, 250 watt lamp. Also be sure to match the lamp type to the proper ballast even though the wattage is the same. HPS ballast to HPS lamp, Metal halide ballast to metal halide lamp and mercury vapour lamp to mercury vapour ballast.
No, a 175-watt metal halide bulb should not be used in a 100-watt ballast fixture. The wattage of the bulb must match the ballast's rating for optimal performance and safety. Using a bulb with a higher wattage than the ballast can lead to overheating, reduced lifespan, and potential damage to both the bulb and the ballast. Always ensure compatibility between the bulb and ballast specifications.
400w is the power 110 is the voltage. Is your light using 110v already or 220v? Believe you are already running at 110 and u don't understand electrical terms. Perhaps you should call an electrician
Yes, you can run a 400-watt metal halide (MH) bulb in a 600-watt high-pressure sodium (HPS) fixture, but you need to ensure that the ballast is compatible with the MH bulb. Using a 400-watt MH bulb in a 600-watt ballast may lead to reduced efficiency, as the ballast will deliver more power than the bulb requires. It's essential to check the ballast type and ensure that it can operate both bulb types safely. If not compatible, it's best to use the appropriate ballast for the MH bulb to avoid damaging the bulb or the fixture.
6000lm
No. A 70 Watt metal halide bulb can not be replaced with a 150 Watt halide bulb.
It will power two 400 watt lamps.
It would depend on the wattage of the fluorescent tubes. As a rough estimate, you would need about 6-8 standard 40-watt fluorescent tubes to approximate the light output of a 1000-watt metal halide bulb.
The lumen output of a 70 watt Metal Halide lamp is typically around 5600 to 6300 lumens. However, due to losses in the fixture including the reflector and lens, the actual light output may be reduced by approximately 20-30%. This could result in an effective lumen output of around 3900 to 5040 lumens for a 70 watt Metal Halide Recessed Down Light.
No, the ballast has to be matched to the lamp. 250 watt ballast, 250 watt lamp. Also be sure to match the lamp type to the proper ballast even though the wattage is the same. HPS ballast to HPS lamp, Metal halide ballast to metal halide lamp and mercury vapour lamp to mercury vapour ballast.
It depends......perhaps 7400 to 8500 initial lumens degrading to 5400 lumens.
400 watt metal halide fixtures can be purchased at various sites on the internet. Some sites that you may want to try out include the following: Amazon and Home Depot.
The light bulb needs to match the ballast in the fixture.
No, it is not recommended to use a 70 watt metal halide lamp with a 150 watt ballast. The lamp and ballast wattage should match to ensure proper operation and to prevent damage to the lamp or ballast. It is best to use a compatible lamp and ballast with matching wattages.
From 20,000 to 23,000 lumens depending on the brand.Average figures:Incandescent: 10 lumens per wattHalogen 13 lumens per wattCFL (low-energy) 50 lumens per watt
25