A zero watt bulb does not consume any power, so it does not have a voltage rating. Voltage is a measure of electrical potential difference, typically associated with the amount of energy transferred per unit charge. In the case of a zero watt bulb, there is no power being consumed, so there is no voltage required to power it.
the zero bulb required less amount of electricty to glow the voltage of bulb is below 5 volt
A 120 volt table lamp with a 75 watt bulb will pull 0.625 amps. With a 100 watt bulb it will pull 0.833 amps. And with a modern fluorescent 13 watt bulb it will pull 0.108 amps.
It is drawing .06 amps.
40 watt light bulb. This is obvious. Go do an experiment. -_-
Yes. It just won't be as bright.
yes the bulb will actually last longer
the zero bulb required less amount of electricty to glow the voltage of bulb is below 5 volt
A zero-volt bulb actually runs on some fixed supply voltage, so the term is not strictly correct. The voltage times the current in amps will give the power used by the bulb in watts, which is converted into watt-hours of energy by multiplying by the number of hours used.
no , it will burn out
No, they do not draw the same current. The current drawn by an electrical device is determined by the power (Watts) and voltage (Volts) using the formula: Current (amps) = Power (Watts) / Voltage (Volts). So, the 12 volt 50 watt bulb will draw higher current compared to the 230 volt 50 watt bulb.
12 volts is enough for a 12-volt 100-watt light bulb. It would not be enough for a 120-volt or 240-volt bulb.
the 220 volt bulp in 220 volt ac current
Yes, you can use a 10 watt 12 volt bulb instead of a 5 watt bulb as long as the fixture can handle the higher wattage. Just be aware that the 10 watt bulb will be brighter and may generate more heat, so ensure there is proper ventilation and that the fixture can handle the increased power load.
Yes a 220 volt light bulb will run on a 120 volt circuit but at 1/4 of the wattage that the light bulb is rated at. A 100 watt light bulb on 220 would would be equal to a 25 watt light bult on 120 volt system.
No, a 6 volt battery is not strong enough to power a 40 watt bulb, which typically requires around 12 volts to operate efficiently. You would need a higher voltage power source to light up a 40 watt bulb.
No, an 18 watt bulb typically requires a higher voltage than what is used in low voltage outdoor lighting systems. Using a higher wattage bulb in a low voltage system can cause damage to the bulb and the lighting system. It is recommended to use bulbs specifically designed for low voltage outdoor lighting.
If the bulb is a 40 watt, 120v bulb, you would need 20 6 volt batteries wired in series, or 80 (!) 1.5 volt batteries. 1.5 volt batteries are AAA, AA, C, D, etc. Since this solution is rather extravagant, try finding a light bulb made for an RV. These typically run off of 12 volts, and you can get a single 12 volt battery, or 2 6 volt batteries, to run this bulb.