Depends on the size of the circuit which you did not list.
Depends on length. The more length, the more resistance.
The 240 volt receptacle has to have an amperage rating. It is this rating that governs the wire size and breaker size to feed the circuit. The new two pole breaker will be inserted in the 100 amp distribution if space is available and connected to the new wiring that terminates at the new receptacle.
i just left lowes an they told me to run 100 amp to my building i would need wire size 2-2-2-4 alumninum and run it in conduit the lowes around here does not sell copper wire that size
A 100 amp service requires that you use AWG 4 copper wire or AWG 2 aluminum wire.
A 3/0 aluminum conductor will limit the voltage drop to 3% or less when supplying 150 amps for 150 feet on a 240 volt system. This size will allow the conductor to be loaded to 120 amps. 150 x 80% = 120 Conductors are only allowed to be loaded to 80% or their rated capacity. If you need the full 150 amps then you would need to use a wire with a rating of 190 amps. 190 x 80% = 152 amps A 4/0 aluminum conductor will limit the voltage drop to 3% or less when supplying 190 amps for 150 feet on a 240 volt system.
Depends on length. The more length, the more resistance.
2AWG.
For a 75 amp circuit with a 100 ft run, you would need a #4 AWG copper wire to ensure minimal voltage drop and to meet electrical code requirements. Using the correct wire size helps maintain the efficiency and safety of the circuit.
For a 220 volt 100 amp breaker, you would typically need a wire gauge of 2/0 AWG (American Wire Gauge) or larger. It is recommended to consult with a professional electrician to ensure the proper gauge is used for your specific installation.
The 240 volt receptacle has to have an amperage rating. It is this rating that governs the wire size and breaker size to feed the circuit. The new two pole breaker will be inserted in the 100 amp distribution if space is available and connected to the new wiring that terminates at the new receptacle.
For a 100 watt 12 volt lamp, you should use a wire gauge size of at least 18 AWG to ensure it can handle the current without overheating. It's always best to refer to the manufacturer's recommendations for the specific lamp you are using.
i just left lowes an they told me to run 100 amp to my building i would need wire size 2-2-2-4 alumninum and run it in conduit the lowes around here does not sell copper wire that size
Use the Related Link Website. At the same website check out wire size calculator. You need a #8 wire to get a full 30 load at 100 feet.
A 100 amp service requires that you use AWG 4 copper wire or AWG 2 aluminum wire.
# 4 copper wire short distance.
A 3/0 aluminum conductor will limit the voltage drop to 3% or less when supplying 150 amps for 150 feet on a 240 volt system. This size will allow the conductor to be loaded to 120 amps. 150 x 80% = 120 Conductors are only allowed to be loaded to 80% or their rated capacity. If you need the full 150 amps then you would need to use a wire with a rating of 190 amps. 190 x 80% = 152 amps A 4/0 aluminum conductor will limit the voltage drop to 3% or less when supplying 190 amps for 150 feet on a 240 volt system.
This will depend on the size of the 12 v battery.