0
What else can I help you with?
Is a 50 amp sub panel enough to do a bathroom and kitchen?
Possibly if the kitchen does not have an electric over and electric cook-top and no eclectic water heater in the bathroom. If they are electric have an electrician evaluate what is being powered in the kitchen and the bathroom to determine if a 50 amp sub-panel is large enough. I would for sure at least go with a 60 amp sub-panel.
How do you wire in for two dryers?
You need two separate 240 VAC circuits from your electric panel that are each rated at 30 amps if they are electric dryers.
Electrical wire sheathing should not project more than about 1 inch into the Aplumbing line B floor joist C electrical panel D ground?
Electric Panel ---------------------------- Based on the answers you have proposed, Electric Panel is the correct choice. However, I do not know of any requirement in the NEC that prohibits the sheathing from extending further into the panel. There is a requirement that it must extend through the connector, but I know of no NEC requirement on when it must stop. --Sparkfighter
How do you tell the meter amperage of your homes electric meter?
Your main breaker should tell you the amps of your panel.
Can a circuit with a GFCI be shared at the box?
Your question is a bit vague, but let's try a two part answer. If you have a GFCI breaker in an electric panel you should only have one connection at the breaker, but the breaker will protect all devices on the circuit. If you are talking about a GFCI outlet, they are equipped to extend the GFCI protection to other non-GFCI outlets by using the proper "output" connection on the GFCI.
Can you provide me with an electric panel diagram for the circuit in question?
I can provide you with an electric panel diagram for the circuit in question.
How do you remove in ceiling speakers?
Removing in-ceiling speakers must take into account the type of ceiling in which they are installed. Typically the panel that the speaker is set in can be lowered and the speaker can be lifted out for removal.
Where is the fuses for the 2002 highlander power outlets?
The fuses for the 2002 Toyota Highlanders power outlets are located in the fuse panel, near the hood release. They prevent an overload the vehicle and the equipment plugged into the outlets.
How do you Clean a suspended Ceiling?
It may be easiest to remove panel by panel and lightly scrub with a soft brush and soapy water.
What is the energy transformation of an electric gate with a solar panel?
Well, it would be solar to electric. Right? Because if the way to operate a gate has a solar panel, but the gate is electric, it would be solar to electric.
How to wire a bedroom for electrical outlets and lighting fixtures?
To wire a bedroom for electrical outlets and lighting fixtures, you will need to plan the layout, install a circuit breaker panel, run wires from the panel to outlets and fixtures, connect the wires to the outlets and fixtures, and test the connections to ensure they are working properly. It is recommended to hire a licensed electrician for this task to ensure safety and compliance with building codes.
What houses are fit for tin ceiling?
Any ceiling can be fitted with a tin ceiling, whether a traditional tin ceiling or one fitted into a drop ceiling panel frame. Tin ceilings are generally purchased in panels and are available in a wide variety of both traditional and modern patterns.
What are the benefits of using ceiling panels?
Depending on which type of ceiling panel, there are several benefits. Radiant ceiling tiles are an economic heating alternative. Suspended ceiling tiles enhance a room's appearance and provide sound insulation. Acoustic ceiling panels provide further sound control.
How to wire a basement for electrical outlets and lighting?
To wire a basement for electrical outlets and lighting, you will need to plan the layout, install a circuit breaker panel, run wiring to outlets and light fixtures, and connect them to the panel. It is important to follow local building codes and safety guidelines when doing electrical work. Consider hiring a licensed electrician for complex projects.
Can I use the Peerless SA745PU Universal Articulating Flat Panel Wall TV Mount to suspend a TV from my ceiling?
It is best to use one designed to mount on the ceiling.
What is the recommended height for installing an electric panel in a residential building?
The recommended height for installing an electric panel in a residential building is typically around 5 feet from the floor to the center of the panel. This height allows for easy access and operation of the panel while standing.
What is the DB panel?
A DB panel is a shortened form for a distribution panel, a panel carrying the fuses, terminals, and other components of a number of subsidiary electric circuits.
