arc length = angle/360 x r 60/360 x 30 = 5
The radius of the sector with an angle of 27 degrees and arc of 12cm is: 25.46 cm
Degrees of rotation does not convert directly to millimeters so the question in its current form has no answer. However, if the question is, "Given a known radius measured in millimeters and given a known angle in radians how do you find the length of the arc formed?" then the answer is: s = rθ Where s = the length of the arc r = the radius in question θ = the known angle Example radius = 20mm θ = 0.52 radians (30 degrees) s = (20)*(0.52) = 10.47mm If your θ is in degrees then the formula s = rθ will look like this: s = rθ*pi/180
Start with a circle of radius equal to the height of a right cone that would be the extension of your frustum. Measure or calculate from the bottom of the frustum up the side and subtract that from the first radius. This remainder is a radius to form a smaller circle concentric with the first one. Now determine the length around the top and bottom of the frustum. This will correspond to a number of degrees within your circles. Draw this angle from the center to the edge of the outer circle. Now cut out the small circle and then the angle section. This should roll into the shape you want. If you use paper for this, be mindful of the grain of the paper. Poster board only rolls in one direction.
It is the angle between the cutting edges.It is usually 118 degrees
solid angle is the ratio of the intercepted area dA of the spherical surface , described about the apex O as the centre ,to square of its radius r
The radius of the sector with an angle of 27 degrees and arc of 12cm is: 25.46 cm
If a sector has an angle of 118.7 and an arc length of 58.95 mm its radius is: 28.45 mm
The measure of the central angle divided by 360 degrees equals the arc length divided by circumference. So 36 degrees divided by 360 degrees equals 2pi cm/ 2pi*radius. 1/10=1/radius. Radius=10 cm.
The answer depends on what information you do have: radius, arc length, central angle etc.
The area of the sector is: 221.2 cm2
Use the formula for the area of a circular sector, and solve for the angle.For a circular sector: area = radius squared times angle / 2 (Note: The angle is supposed to be expressed in radians; and in this specific problem, there is no need to convert it to degrees.) Since you know the area and the radius (according to the comments added to this question), you can solve for the angle. Once you know the angle (in radians!), the arc length is simply angle x radius.
Find the area of the shaded sector. radius of 3 ...A+ = 7.07
To calculate the arc length of a sector: calculate the circumference length, using (pi * diameter), then multiply by (sector angle / 360 degrees) so : (pi * diameter) * (sector angle / 360) = arc length
The arc length divided by the radius is the angle in radians. To convert radians to degrees, multiply by (180/pi).
It's 0.524 of the length of the radius.
Length of arc = pi*radius*angle/180 = 10.47 units (to 2 dp)
That will depend on the length or angle of the arc which has not been given