0
What else can I help you with?
What powerful hammer is used to chip concrete and is also a boys name?
Jack
What is a powerful hammer used to chip concrete that is also a boys name?
Jack
Is it safe to remove concrete?
yes if you are a professinoal It is Fairly safe to remove concrete however if the proces involves cutting and jack hammering take care that you wear protective equipment that stops you from inhaling the dust.
What is the difference between reinforced concrete and pre stressed concrete?
Reinforced concrete has reinforcing bars (called rebar) simply embedded in the pour. With prestressed concrete, reinforcing rods or cables are stretched (stressed) and then the concrete is poured around them. After the concrete hardens, the tension on the reinforcing members compresses the concrete, making it more resistant to failure where poor soil conditions or severe loads exist.Prestressed construction is usually done in-plant because of the equipment involved, and the completed assembly shipped to the site for installation.A similar method, called post-tension, is usually done on site, and involves the tensioning of reinforcing cables after the slab is poured, using a special hydraulic jack.
What are the pros and cons of building a basement floor of wood or pouring concrete in a new basement with concrete walls?
the pros of building a floor for a basement out of wood is that if there is some soort of sewage pipe leake then you dont have to pull out the jack hammer or hammer and chisel. the con is termite, ants, insects and, rot
How much does a cubic yard of navvy jack weigh?
A cubic yard of navvy jack typically weighs around 2,400 to 2,800 pounds, depending on the specific composition and density of the material.
What powerful hammer is used to chip concrete and is also a boys name?
Jack
What is a powerful hammer used to chip concrete that is also a boys name?
Jack
What has the author Milton Jack Snyder written?
Milton Jack Snyder has written: 'Protective coatings to prevent deterioration of concrete by deicing chemicals'
What should you use to support a vehicle after you have raised it with a jack?
A jack stand or something really secure, like a couple of concrete blocks beneath the axle.
Is Jack going to come and be in Doctor Who again?
It is unclear if Jack is going to be a doctor because there is no information about who Jack is. A last name is required to fond information about him.
What do you use to turn concrete into gravel?
jack hammer, sledge hammer, lots of time, lots of work
How to remove a fence post that is set in concrete?
To remove a fence post set in concrete, you can use a combination of tools and techniques. First, dig around the post to expose the concrete base. Then, use a jack or lever to lift the post out of the ground. If necessary, break up the concrete with a sledgehammer or concrete breaker. Finally, remove any remaining concrete and fill the hole with soil.
What capacity hydraulic jack is required to give pressure of 2 ton per square inch?
around 50 ton jack
How can I use a DIY method to lift a concrete slab?
One DIY method to lift a concrete slab is by using a jack and some wooden blocks. Place the jack under the slab and slowly raise it by pumping the jack. Insert wooden blocks under the slab as it lifts to support it at the desired height. Be cautious and ensure the slab is lifted evenly to prevent cracking or damage.
Is it safe to remove concrete?
yes if you are a professinoal It is Fairly safe to remove concrete however if the proces involves cutting and jack hammering take care that you wear protective equipment that stops you from inhaling the dust.
How do you build a mud jack pump?
To build a mud jack pump, you will need a tank to hold the mud slurry, a pump with sufficient pressure capacity, hoses to transport the mud, and a nozzle to inject the mud under the concrete. Assemble the components according to the manufacturer's instructions, ensuring the pump is capable of mixing and delivering the required slurry mixture at the correct pressure for mud jacking.
