0
What distance in metres on the ground is the equivalent of one second of arc in longitude or latitude?
Wiki User
∙ 16y ago
One minute of arc as measured at the centre of the Earth covers one nautical mile on the surface of the Earth at mean sea level. One nautical mile is 6080 feet or 1853.2 metres.
Therefore one second of arc would be 6080 / 60 = 101.3 feet or 30.886 metres.
Lines of latitude are at regular intervals parallel to the equator. The relationship between degrees of latitude and the distance spanned on the earths surface remains constant. Therefore at all latitudes 1 minute of latitude spans 1 nautical mile on the earths surface.
Lines of longitude converge at the poles. Therefore the relationship between degrees of longitude and the distance spanned on the earths surface is reduced as the poles are approached.
At the equator the distance spanned by 1 minute of longitude would be 1 nautical
mile. At the poles it would be zero.
To calculate the actual distance on the surface of the earth between two points of known latitude and longitude requires a knowledge of spherical trigonometry to calculate the great circle distance between the two points.
The distances quoted are for the surface of the earth at mean sea level. Distances will be increased above sea level and reduced below it.
Wiki User
∙ 16y ago
Add your answer:
Earn +20 pts
What is ground roll?
The distance the aircraft travels on the ground before lifting off, or the same when landing.
How do you measure a downgrade so that you can dig a drain culvert through uneven ground . . . so that the drain tile will really drain?
One possibility suggested is to drive fence posts into ground at begining and end of the area and tightly tie a string and then LEVEL the string before measuring the distance from string to the ground at each fence post. Is there a better way?
What should be the transformer to building separation distance for fire suppression?
Depends on size of transformer and type (dry,mineral oil, silicone) as well as ground slope and building construction.
What is the advantage and disadvantage of open delta bank transformer?
A disadvantage with Open Delta is there are no phase-ground voltage measurements, which is only a disadvantage if directional relaying or distance relaying is needed. Some directional and voltage based ground fault detection relays don't work without the phase to ground input. Since most industrial systems MV are high resistance grounded and ground fault protection is provided by overcurrent, there isn't a need for the phase-ground measurements.Why will the directional or distance relaying not work in this case?5. Most directional and distance relays need a voltage to ground reference to compare with the phase current nfr groudn faults. Some can use a zero sequence polarising current from CT's on the neutral of the transformer, but most need phase-neutral voltages for accurate calculation of fault direction and distance.The relay needs to see a zero sequence voltage to compare to the zero sequence current to find out which direction the current is flowing.Precise Phase-ground voltages are needed for this type of calculation, whether it is done digitally or with analog circuits or windings, coils and phae shifting circuits.The voltages provided by the Open Delta do not have enough zero sequence component.
Does voltage on ground mean open ground?
Voltage on ground can mean an open ground. It can also mean (high) current on ground, due to a ground fault such as reversed neutral and ground.
Which is not contained within Earh'ssystm of latitude and longitude?
ground elevation
What is the latitude and longitude of a nickel?
Latitude and longitude are numbers that describe the location of a point on the Earth's surface. A nickel is not nailed down, so you can move it around to any place on Earth, drop it on the ground, and give it any latitude and longitude you want.
What are The degrees of latitude and longitude that describe a specific place on earth?
If you give me accurate and precise numbers for the latitude and longitude of a point on the surface of the earth, I can use those numbers to go to the right place, and stick a pin in the ground within an inch of the exact spot.
What is 1 degree of longitude?
One degree of longitude is approximately 69 miles (111 km) apart at the equator; since they converge at the North and South Poles, the distance gets smaller as they near the poles.
What is the latitude and longitude for Tampa General Hospital?
The center of the drive-through circle, off of Tampa General Circle, on the south side of the Surgical Center, is located at 27.9375° north latitude 82.4592° west longitude. Around the back, as far back as you can drive on the north side, just west of the pedestrian bridge to the Rehab Center, by the big white tank on the ground, where you can still see the helicopter pad on the edge next to the water, the coordinates are 27.9390° north latitude 82.4593° west longitude.
How many longitude and latitude coordinate positions are there in the world?
There are infinite longitude and latitude coordinate positions in the world, as they form a continuous grid system covering the entire surface of the Earth. Each point on the Earth's surface can be pinpointed by a unique combination of latitude and longitude values.
What is farthest point on earth from Toronto?
The entrance to the terminal building at Billy Bishop airport downtown is located at 43.632° north latitude 79.397° west longitude. If you dig a hole straight down into the ground from that place, through the center of the Earth and out the other side, you'll emerge at 43.632° south latitude 100.603° east longitude. The overland distance to that point from Billy Bishop is 1/2 the circumference of the Earth ... roughly 12,430 miles. The point is located in the southeastern Indian Ocean, about 1,290 miles southwest of Perth, Australia.
What are the lines that circle the globe in east-west and north-south directions?
"Lines of Latitude" and "parallels" are both used. Please note that the "lines" are imaginary; you'll never see one on the ground. Just on a map.
How far apart in miles are the lines of latitude?
AnswerThere is no standard set of "lines", and no standard distance between them. A 'line' can be drawn at any latitude, or not.One degree of latitude represents about 111.1 km or 69 statute miles,regardless of how many lines are or are not drawn in it.
What changes with latitude?
As you move away from the equator towards the poles, several things change with latitude. These changes include temperature, day length, and the angle of sunlight, all of which can affect weather patterns and ecosystems in different regions.
How are distances measured on a map?
Distances on a map are usually measured using a scale. The scale is a ratio that represents the distance on the map to the actual distance on the ground. For example, a scale of 1:100,000 means that 1 unit on the map represents 100,000 units on the ground. This allows you to calculate the actual distance between two points on the map.
Bar scales are used to convert map distance to ground distance?
Yes, bar scales are used to convert map distance to ground distance.
