If your bag length is 500mm long, the circumference of your drum including your printing plate shall be 500mm. Hence find the diameter of the drum and the plate, then deduct twice the plate thickness (say if the plat is 4 mm, it comes on both sides, so deduct 8mm from the diameter) and derive the circumference of the drum from this number.
8mm
8mm rebar weighs 0.395kg/m
Most common is media conversion. Audio cassettes, 8mm audio/video tape and LP records.
0.395 kgs = unit wt of 8 mm dia rebar There is another way of calculating the specific weight (or unit weight) of a rebar. Especially for those who are interested of rebars less than 10mm of dia. the way is to calculate it mathematically knowing that the density of steel rebars is 7851 Kg/m3. 8mm rebar ==>Unit weight [Kg/m] = Cross-Sectional Area [m2] x Density [kg/m3]= (Pi)x(radios)2 x 7851 kg/m3 = 0.395 Kg/m Good luck !!
68.95
The unit weight of a 8mm thick stainless steel plate (SS 409) is approximately 64.8 kg/m^2. This value may vary slightly based on the specific composition of the stainless steel material used in the plate.
68.8
8mm glass is 20KG per sq metre 10mm glass is 25kg per sq metre
1.5 x 6 x 0.008 x 7680 = 552.96 Kg
Ceramic 12kg per m2 Porcelain (8mm thick) 20kg per m2 Porcelain (10mm thick) 25kg per m2 Natural Stone (10mm thick) 28kg per m2 Natural Stone(20mm thick) 35kg per m2
The question has o sensible answer for two main reasons.The material of the plate is not mentioned. Different materials have different densities (or specific gravities) and so their weights will be different.It is not possible to give the weight in kilograms because weight is measured in Newtons, not kilograms. Mass is measured in kg.
It depends but on average 8mm long with a thick waxy waterproof coat!
First the fill hole has a hex head socket screw in the top of the trans. second you have to pull the cover plate over the gear box (4-8mm bolts) once that is removed there is a metal plate on the end of the trans. with 5 8mm bolts holding it on. In the center there is a 8mm screw in the center of that plate remove that. Fill the trans. from the top hole until oil comes out of the hole you removed the 8mm screw from. replace the 8mm screw then the hex head socket screw in the top, as well as the cover plate. CAUTION: PREFORM THIS WITH THE BIKE ON THE CENTER STAND.
Alberta Canada requires 5/16 inch or 8MM above rivet head or if bonded friction material, 8mm above metal.
The weight an 8mm bolt can hold depends on factors such as the material of the bolt, the quality of the threading, and how it is being used. In general, an 8mm bolt made of steel can typically hold several hundred pounds when inserted in a secure manner. For specific weight capacities, it is recommended to consult with the manufacturer or engineering guidelines.
0.39 kg/metre