This question cannot be answered since a box has length, width and height. It is a three dimensional object and only two are given.
Yes, with a stone cutting blade, but it would have to be a blade made to cut while dry and it would be a slow process with lots of dust.
Faceted diamonds are cut from raw stones by diamond cutters who are trained to plan and execute a cut. The goal is to preserve as much of the natural characteristics of the stone as possible, such as its clarity or colour, with the highest remaining carat weight. (About 60% of the raw stone is lost in the cutting process.)
porosity is the process produced.
With a circle use the formula Pi x D, where Pi is a constant and D is the diameter. With polygons it is the sum of the length of the sides
Assuming that the diamonds are about the same size:Cut diamonds are worth more, because of the additional labour involved in planning, cutting and polishing the stone to reveal its finest characteristics.The process, above, can remove sometimes up to 60% of the stone in order to show off the stone's best.Raw, uncut diamonds have value, but not as much value as they will have once they are fashioned into eye-catching gems.However, a large raw diamond may be worth more than a small, cut stone.
You are going to make a box out of cardboard. The box needs to measure 10 cm by 5 cm by 5 cm; 10% of the final product will be wasted in the cutting process. How much cardboard do you need?
250cm
255cm2
To figure out the full amount of cardboard needed you have to determine what 10 percent is of each measurement. Ten percent of ten is 1, and ten percent of five is .5. Therefore, you will need 22 cm of cardboard.
275 cm. mars4045: very smart!
Four sides @ 10 x 5 plus two ends @ 5 x 5= 250 + 10% = 275 cucm
Total Area = 2(Areahw) + 2(Areahl) + 2(Areawl) =2(10*5)+2(10*5)+2(5*5) =100+100+50 =250cm^2 plus 10% waiste =250*(1+0.1) =275cm^2
The process is called diamond cutting.
The process of cutting a hedge is called Topiary
Raw diamonds are cut based on a plan for the cut, which intends to preserve the raw stone's natural colour and the most of its carat weight possible. About 60% of a raw diamond's carat weight is lost in the cutting and polishing process. You can read more below about the American Institute of Diamond Cutting, which explains their curriculum, but lacks any named 'unit of measure' used in the process.
tapping is a metal cutting process & rolling is a forming process.
Plasma Cutting is process by which all types of conducting materials can be cut. This is an economic commonly used process for steel cutting in the industry today.