Line. If you think of the tip of a pencil as the dot, and you drag it across paper, you get a line that can vary in both length and width.
This is a bit arbitrary, but the name "length" is often reserved for the longest measurement, and the "width" would be perpendicular to the length.This is a bit arbitrary, but the name "length" is often reserved for the longest measurement, and the "width" would be perpendicular to the length.This is a bit arbitrary, but the name "length" is often reserved for the longest measurement, and the "width" would be perpendicular to the length.This is a bit arbitrary, but the name "length" is often reserved for the longest measurement, and the "width" would be perpendicular to the length.
cube
length
A Scalene triangle has no sides of equal length.
An isosceles triangle has exactly two sides that are equal in length.
This is a bit arbitrary, but the name "length" is often reserved for the longest measurement, and the "width" would be perpendicular to the length.This is a bit arbitrary, but the name "length" is often reserved for the longest measurement, and the "width" would be perpendicular to the length.This is a bit arbitrary, but the name "length" is often reserved for the longest measurement, and the "width" would be perpendicular to the length.This is a bit arbitrary, but the name "length" is often reserved for the longest measurement, and the "width" would be perpendicular to the length.
It has no specific name. It is unusual, though, because its length is smaller than its width!
You can not name countries by diametres, as they are not circles. You can name them by length/width, in which case Russia would be the largest in length/width.
If a rectangle has its length equal to its width, then all four sides are of equal length and it is a square.
There is no special name.
cube
Yes, Oblong is the name of a rectangle who's length is greater than it's width.
Rectangle
1. the width of aisles2. the length of freezer units 3. the height of shelving 4. the length of deli counter 5. the width of gaps between checkout points.
Before the increase it would be length 14 width 11, after L 15 W 11. BTW length is kind of a generic term for use for the name of a specific side, height would have been a better choice.
A 3D figure has length x width x depth. It becomes a 2D figure once the removed surface is laid flat, having then only length x width. Another name is "Plane Figure."
The volume of a cube is referred to as cubic volume. It is found by multiplying the length, width, and depth together.