answersLogoWhite

0

Close to Distributor you will find it protruding from a wiring harness . You simply pull on it to remove for timing proceedures.

User Avatar

Wiki User

14y ago

What else can I help you with?

Related Questions

What is the timing set for a 89 aerostar?

10 deg BTD, tranny in neutral, spout connecter disconnected


Where is the spout connecter on a 1992 inline six?

On a 1992 inline six engine, the spout connector is typically located near the ignition module or the distributor. It is usually a single-wire connector that can be easily identified by its distinct color or design. The spout connector is used to advance the ignition timing during diagnostic procedures. To access it, you may need to remove some components or look near the engine's front or side.


What are all the computer ports names?

USB, IEEE 1394 ps/2 PS/2 ethernet port lpti vga line in microphone gamejack


What are sentences of spout?

The whales spout water every so often. The water spout is clogged.


Where is the single wire in line spout connector on 93 f150?

Drivers side fender well by the hood hinge


What is the spout on a teapot called?

The spout on a teapot is commonly referred to simply as the "spout." It is the part of the teapot designed for pouring tea from the vessel. Some teapots may also have a "spout lip" or "spout tip," which refers to the end of the spout that directs the flow of liquid.


How can I fix a diverter tub spout?

To fix a diverter tub spout, you can start by removing the spout and checking for any blockages or debris. Clean the spout and the pipe it connects to, then reattach the spout securely. If the issue persists, you may need to replace the diverter valve inside the spout.


What do you call the projecting mouth of a kettle?

the SPOUT .


How do you set the timing on a 1998 Ford Contour with a 2.0L d o h c?

I believe on the car you need a special tool that inserts into the back of the cams to hold them in place. So if your question is "how do I reset the timing after I change gears, belt, or cams," the answer is make sure you get that tool first. Second check to see if there is a spout connector on the car, if there is disconnect that. If you don't know what a spout connecter is, look at the vehic. identifacation sticker, it should give you some info on timing. There it will say if there is a spout connector. When the connector is taken off timing should be as normal marks on the dampner pully with the correct mark of degree. The correct mark of degree is also on the vehic. identifacation sticker. there is no spout connector you just put a flat bar in the end of the cams to hold them in place and then there are two marks on the crank pulley and you line up the one on the right to the mark below it(on the oil pan).


What is a spout?

A spout is a tube or lip through which liquid is poured.


Does the rain flow out of the spout eaisly?

no, it does not flow out of the spout eaisly


Can a sperm whale smell with his spout?

No. They blow their breath out of the spout.