appale
no 25 mbps is up not 100
1) Convert the 4 Mbps to MBps. (The transfer speed is specificed in mega-bits per second; 1 byte has 8 bits). That is, 4 Mbps / (8 bits/byte) = 0.5 MBps. 2) For file sizes, MB usually refer, not to a million bytes, but to 10242 bytes, so you may want to multiply the 100 MB by 1.0242. 3) Finally, divide the result the transfer speed (in BYTES per second!), to get the number of seconds. Depending on the result, you may want to convert this into minutes, hours, or even days. If you omit step 1 (confusing bits with bytes), you'll be off by a factor of 8; if you omit step 2, you'll only be about 5% off.
Full duplex means it can receive and send at the same time.10 100 means it supports both of these speeds (10 Mbps and 100 Mbps).Full duplex means it can receive and send at the same time.10 100 means it supports both of these speeds (10 Mbps and 100 Mbps).Full duplex means it can receive and send at the same time.10 100 means it supports both of these speeds (10 Mbps and 100 Mbps).Full duplex means it can receive and send at the same time.10 100 means it supports both of these speeds (10 Mbps and 100 Mbps).
Cat5e is 100 mbps.
100 megabits per second (Mbps) = 12800 kilobytes per second (KBps)
It's not that much faster -- maybe a little over twice as fast. DSL gives you 1,500 Mbps and cable can go as high as 8,000 Mbps. ^ This is wrong (old answer) ^ First, 'b' is Bit, 'B' is Byte. There are 8 bits in a byte In the case of the question (Megabits per seconds): 100.0 Mbps is equivalent to 12.5 MBps (Megabytes per second). Dial up modems are (generally) capable of doing 0.056MBps (56Kbps) maximum, 100.0 Mbps (12500Kb/s) is ALOT faster!
change security setting to wap2
10-Mbps Ethernet, 100-Mbps or Fast Ethernet, and 1000-Mbps or Gigabit Ethernet.
100 mbps, is very fast internet. Its about 4 min.
100 Mbps. There are several speeds for Ethernet; the term "Fast Ethernet" is used for the 100 Mbps variety.
1000000 mbs