Radius = 10
Diameter = 20
Circumference = pi D = 20 pi.
50 degrees = (50 / 360) of the whole circle.
Arc length = (50 / 360) of (20 pi) = (1,000 pi / 360) = 8.727 cm (rounded)
Mark out 10 by 36 degree arcs around its circumference and then join them up to the center of the circle.
A degree is 1/360 of a circle.
A circle has a total of 360 degrees. This measurement is used to describe the angle formed at the center of the circle when two radii are drawn to the circumference. Each degree represents a fraction of the circle, allowing for precise measurements of angles and rotations.
Perpindicular lines are like the lines in the letter "T". The intersect each other at a 90 degree angle. A radius is the distance from the center of the circle to the circle itself. It is half the circle's diameter.
A 60-degree radius refers to a specific portion of a circle, where the radius is the distance from the center of the circle to its perimeter, and the 60 degrees represents the angle subtended at the center. This means that the arc created by this angle spans one-sixth of the full circle (360 degrees). In practical terms, it can describe a segment of a circular path or area, often used in geometry or design contexts.
Mark out 10 by 36 degree arcs around its circumference and then join them up to the center of the circle.
Yes, a circle is in fact composed of a degree or angle.
A degree is 1/360 of a circle.
Perpindicular lines are like the lines in the letter "T". The intersect each other at a 90 degree angle. A radius is the distance from the center of the circle to the circle itself. It is half the circle's diameter.
A 60-degree radius refers to a specific portion of a circle, where the radius is the distance from the center of the circle to its perimeter, and the 60 degrees represents the angle subtended at the center. This means that the arc created by this angle spans one-sixth of the full circle (360 degrees). In practical terms, it can describe a segment of a circular path or area, often used in geometry or design contexts.
A 130-degree radius typically refers to a circular arc or sector with a central angle of 130 degrees. In this context, the radius is the distance from the center of the circle to any point on its circumference. This means that if you were to draw a circle with a radius of a specific length, the arc defined by a 130-degree angle would represent a portion of that circle, covering about one-third of its total circumference.
Measure using a protractor and then split it every 40degrees. DoNe
Radian is the unit used to measure distances around a circle. It is defined as the angle subtended at the center of a circle by an arc equal in length to the radius of the circle.
There are 360 degrees in a circle and so 1 degree is 1/360
Cut it in half
1/360
Degree graph has 360 segments , percntage has 100 segments