a point A is 40 mm above hp and 25 mm infront of vp. draw the frontview,topview and right side view
In terms of length, 30mm is greater than 3cm. This is because 1cm is equal to 10mm. Therefore, 3cm is equivalent to 30mm.
30mm*230mm = 6900 millimetres = 271.653543 inches
The volume of a cylinder that is 30mm in diameter and 700mm high is 494,800.84mm3
30mm is approximately 1.18 inches in standard measurement. To convert millimeters to inches, you can use the conversion factor where 1 inch equals 25.4mm. Therefore, 30mm divided by 25.4 gives you about 1.18 inches.
30mm
30mm
It is 30mm
2007 and 2008 350Z Base, Enthusiast, Touring....18" Wheels.... Front 18 x 8 with 30mm offset and Rear 18 x 8.5 with 33mm offset 2007 and 2008 350Z Grand Touring and Nismo ...18" front with 30mm offset and 19" rear with 30mm offset
Try a 30mm socket.
For Axle Nut its 30mm
135cc for 30mm forks
In terms of length, 30mm is greater than 3cm. This is because 1cm is equal to 10mm. Therefore, 3cm is equivalent to 30mm.
30mm
30mm for the front. I think the rear are 24mm, but I usually use an adjustable for those.
to convert 30mm into cm multiply the 30mm by 10. this is because there are 10mm to a cm.
The recommended size for the spindle of a bottom bracket when using a 30mm crankset is typically 30mm.
30mm*230mm = 6900 millimetres = 271.653543 inches