answersLogoWhite

0


Best Answer

20 Nm. You just multiply them together.

User Avatar

Wiki User

15y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: A spanner is used to tighten a nutAforce of 100n is applied 0.2 m from the center of the nut What is the moment?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

Find the torque required to tighten a 10mm nut if the force on the end of the spanner is 10kg and the length of the spanner is 95mm?

The torque required can be calculated as the force applied multiplied by the distance from the center (lever arm). Convert the force from kg to Newtons (10kg = 98.1N) and the length from millimeters to meters (95mm = 0.095m). The torque required is 9.33 N*m (98.1N * 0.095m).


What is the population of Center for Applied Genomics?

Center for Applied Genomics's population is 89.


When was Center for Applied Genomics created?

Center for Applied Genomics was created in 2006.


When was Markkula Center for Applied Ethics created?

Markkula Center for Applied Ethics was created in 1986.


When was Basque Center for Applied Mathematics created?

Basque Center for Applied Mathematics was created on 2008-09-01.


When was Center for Applied Linguistics created?

The Center for Applied Linguistics (CAL) was established in 1959. It is a non-profit organization dedicated to promoting language education and intercultural communication.


What is Basque Center for Applied Mathematics's motto?

Basque Center for Applied Mathematics's motto is 'Matematika mugaz bestalde Mathematics beyond frontiers'.


Head bolt tightening sequence for Mazda e2000?

Begin by tightening the head bolts on each corner of the head. Next, tighten the center head bolts. Tighten the bolts on each end of the head and move towards the center.


Is it possible to adjust or tighten the chain on a 2001 250 polaris trail blazer?

Loosen the 2 bolts on back axle.... then turn the center carrier it is what is called a concentric and will tighten chain. BUT don't tighten to much


How do you tighten a 3 piece crank on the donny Robinson hyper bike?

Pop the cap out of the center of the crank arm and tighten with a 14mm socket. Replace cap when done.


The center of the universe was?

At present, there is no way to determine where the "center" of the universe is, or even if the concept of "center" makes sense when applied to the universe.


How do you remove the rear hub on a 1985 Chevrolet dually?

Loosen and remove center hub bolts Slide axle out Remove spanner nut Remove drum