You can't put miles in terms of square miles because miles is length and square miles is area, its like comparing oranges and apples. A square mile is a mile in length and a mile in width.
per implies that this is a rate measured for one mile (by dividing by a number of miles).
There are 5280 feet in one mile. Therefore, 2100 feet is equal to 2100/5280 miles. Expressed as a proper fraction in its lowest terms, this is equal to 35/88 of a mile. Expressed as a decimal fraction, this is equal to 0.39772 recurring - or 0.39772727272... miles.
in terms of speed, 10 mph. in terms of 400 splits, 1:30 for each 400.
One mile is equal to 5,280 feet. Therefore, 500 feet is equal to 500/5280 = 0.09469 recurring (that is, 0.094696969...) miles. Cancelled down to a fraction in its lowest terms, this is equal to 5/528 of a mile.
A 'click' is a kilometer, approximately 6/10 of a mile. The terms are used interchangably in the military in person or by radio. On documents, the formal 'kilometer' is usually used.
There is @ 1.7 clicks to the mile. Actually just under 1.7. One thousand steps will give you about 3250 feet or one click, give or take. If your step is shorter than a meter/yard, and mine is, it'll take more. So I use 125 steps in the forest to give me one tenth of a click. Ten of these is a click. 17 of these in @ a mile. Doc
half a mile
One mile in length and one mile in width.
1 mile = 1609 m
what is A 1-mile retreat by an army
7 minutes
About 3/4 mile in an army tank or about 75 miles in a Toyota Pirus.
You can't put miles in terms of square miles because miles is length and square miles is area, its like comparing oranges and apples. A square mile is a mile in length and a mile in width.
One nautical mile is equivalent to one minute of latitude. In terms of degrees, one nautical mile is approximately 1/60th of a degree of latitude.
There are typically 1760 yards in a mile in a standard pool.
per implies that this is a rate measured for one mile (by dividing by a number of miles).