There are size on size weldolets. The hold on the run pipe will necessarily be undersize (either hot tap or torch ) because it's not possible to cut the same size hole in the run without damaging the base material.
Chat with our AI personalities
by multiplying the pipe size with the number of welded joints.regardsZH
That depends on the pressure behind the flow, and on the length of time the flow is allowed to continue.
cylinder volume equation: pi*r^2*h r=8in h=12in pi*(8in)^2*12in = 2412.743158 cubic inches.
Reinforcing pads mirror the pipe that they are being welded to in size, thickness, and material. To measure the diameter of the pad, measure the pipe at a cross section.
the answer is 31in. unit