answersLogoWhite

0


Want this question answered?

Be notified when an answer is posted

Add your answer:

Earn +20 pts
Q: Can you cut 4 inches off the side of a fire door?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

How do you cut the door that leads to the scientist with the second stone in fire red?

All you have to do is to stand in front of it. Then select a Pokemon that knows cut and have it use it. The door will open.


How do you get past the guy in front of the steel door on island six on fire red?

you use the hm cut on the door to open it


How do you open the door on island six Pokemon fire version?

Use the move Cut.


How can I cut the melamine cupboard door trim without splitting the material?

Cut it from the unfinished side to avoid splitting.


Why you can't go in that building at six island for fire red?

because u have to cut the door to get into it


What does the riddle mean in the dotted cave after you got the ruby in Pokemon Fire red?

cut the door


When working on fire rated doors can you remove the fire rated tag on the hinge side of the door?

NO. and it cant be painted over either. If you don't like to see the label, cover it with blue painter's tape cut off the excess tape from the edges and then paint the door and over the tape and leave it in place. If you are asked by a fire marshall to show the rating then peel it off. Reapply if desired.


How do you cut a 12 in by 12 in paper and make it a 9 in by 16 in paper?

When you cut it, you make it smaller, but you can take four inches off one side and tape it to the other side.


How do you teach a Pokemon in Pokemon fire red how to cut trees?

Teach it cut, you get it on the side of viridian forest, below diglett cave


How do get the power locks to work on a 98 jeep grand Cherokee?

you have a cut wire in the drivers side door wiring, they get opened & closed so much that wires get cut, open the black boot in the door jam & you'll find your cut wire.


How do you cut off 1 off a metal EXTERIOR door?

You can't really or rather you probably shouldn't. They are hollow and the bottom cut edge will rust no matter what you do to it. Normally, you would make the opening taller. If you had to, cut it with an abrasive blade in a circular saw if possible. This will give you a more even cut. I would either cut a board to fit inside the door and glue it in place, or clamp a 2x4 on either side across the face of the door, making sure thickness of the door was the same in the middle and put spray foam insulation in the bottom. Up at least 6 inches. Trim off the excess that comes out after it has hardened. This should seal the door and glue the two faces together.


How do you get through the dotted hole in fire red?

When you see the strange entrance, use cut to open it. You MUST fall through the holes in this way: North hole. West hole. East hole. South hole.