0
What else can I help you with?
How many 8 inches can you cut from a 120 inches?
120/8 = 15
A piece of pipe is 303.4 inches long If five pieces each 41.3 inches long are cut from the pipe how many inches of pipe remain?
A piece of pipe is 303/4 inches long. If five pieces, each 41/3 inches long, are cut from the pipe, how many inches of pipe remain?
Rectangular cards 2 inches by 3 inches are cut from a rectangular sheet 2 feet by 3 feet. What is the greatest number of cards that can be cut from the sheet?
144 cards
Stan cut a wooden plank into 4 pieces. each piece was 18 inches long how long was the plank before Stan cut it?
Roughly 72 inches. The cuts take up space.
A strip of wood is 66 inches long is to be cut into five and half inches pieces how many can be cut?
You can get at most eleven pieces if your saw has any width at all. (5.5 * 12 = 66 but then the kerf (the saw cut width) is not taken into account.
What is thread depth?
It's the depth of the cut from the crest of the surface down to the base on a bolt or screw.
How do you cut female thread?
In general a female thread is cut with a tap. A male thread is cut with a die.
What is the maximum cut depth of a table saw?
The maximum cut depth of a table saw is typically around 3 to 4 inches, depending on the specific model and blade size.
What is the maximum cut depth of a circular saw?
The maximum cut depth of a circular saw is typically around 2-3 inches, but can vary depending on the specific model and blade size.
What is the maximum depth of cut that can be achieved with a circular saw?
The maximum depth of cut that can be achieved with a circular saw is typically around 2-3 inches, depending on the size and type of the saw blade.
What is the relationship between a nut thread and a screw thread?
when a spiral groove is cut over a hole, then it is nut thread. when a spiral groove is cut over a shaft, then it is screw thread.
When Machining rotors the depth of cut should be no more than 400 inches?
400 inches is a little over 33 feet. .004" is a little more like it.
What is internal thread cutting?
Pitches of thread shall be cut off.
Can you give an example of a g76 cycle for buttress thread?
A G76 cycle for a buttress thread can be programmed in a CNC lathe as follows: G76 P020060 Q0.1 R0.05 G76 X10 Z-20 P500 Q100 F2 In this example, P020060 specifies the thread pitch and angle, Q0.1 is the retract amount, and R0.05 is the thread depth. The second line defines the final diameter (X10), the final length (Z-20), and the thread parameters such as P500 (depth of cut), Q100 (number of passes), and F2 (feed rate). Adjust these values according to your specific buttress thread requirements.
How do you dry crab-apples?
Cut a 36-inch length of thread. Thread your needle and tie a pony bead to the end of the thread. String crab apples until you reach the last 2 inches of thread. Hang each apple string from a hook or drape it over a bar until the fruit wrinkles like a raisin.
Fate who cut the thread of destiny?
atropos.
How do you calculate tonnage of forging press for the part to be forged?
For steel, the formula is (material thickness) x (inches of cut) x 50,000.
