Depends on how big your steps are and how long your legs are.
Neither. Steps are taken, not followed. Use The following steps must be taken.
the answer is......12.88
There are not seven steps unless you start counting steps like "pick up pen"! Three steps is all that it takes.
The chromatic scale is all half-steps, so no formula is required.
yes
No. You need balusters to support the handrails and make the whole structure strong.
InstructionsFind a Place for the Escalator.1 Escalators can transfer more people up shorter distances. It wouldn't make much sense to have an escalator based at the bottom of the Sears Tower go up 100 stories.2 Extra room is always figured into original building plans.Sponsored LinksMotor Control TutorialsFree Web Tutorials from Galil, The World Leader in Motor Control.www.Galilmc.com3 You need enough room for the drive gear and electric motor at the top of where the escalator will be placed, and a return wheel gear at the bottom. Escalator steps usually aren't less than 3 feet wide.Putting it All Together4 The electric motor moves the drive gear, which in turns moves the rest of the machine. A belt from the motor to the drive gear is of upmost importance. Without the belt, nothing else would work.5 Two belt rails must be looped around both the drive gear and the return gear. They must be able to hold all the steps. It works like a train. The steps are placed on the rails and follow them around from top to bottom. A chain is put through the steps to help guide them along the rails.6 Rails must be placed so that the steps will remain level for passengers. This can be done by using triangle shaped steps. At the bottom and top of the escalator ,the rails must be placed so the steps level off to make it easier for the passenger to enter and exit the escalator.The Handrail7 All escalators must have a handrail for safety, which can be installed easily. It uses the same drive gear as the escalator itself, so the handrail and steps travel at the same speed.8 You will need a handrail drive. A belt needs to be looped from the handrail drive to the gear drive. Another belt will go along the handrail drive. This is the actual handrail. They need to be large enough for a passenger to grip the entire way up.9 The handrail also needs to be along a track parallel with the steps. It's usually put on a wall next to the steps, high enough so that passengers are comfortable holding on to it.hiba
what is a type B handrail
Be sure you have a a good grip on the handrail before trying to climb those wet steps.
This probably refers to a handrail that doesn't meet with the current building code standards.
An escalator contains a motor with a pulley, a belt (doubles as the handrail), and many hinged pieces that form the steps. I am pretty sure there are bearings in the tracks.
No; and those that do not are called anoxic steps.
To install a hand rail, you will need to buy a kit. You will also need screws and a screwdriver or an electric drill to install the hardware.
The post actually is the banister. The fat bit that you slide your hand on is called a handrail or a balustrade.
The cast of Handrail - 2013 includes: Elora Espano as Anna Ross Pesigan as Diego
Generally, they are placed four to five feet on center but if you have you are using a weak bracket or railing, they will not be able to spaced that far apart and still meet the load requirements of the building codes. Building codes require that handrail be able to withstand a 200 lb concentrated or 50 lb/ft uniform load. If you use a weak, flexible handrail you will need to place your brackets closer together. Cast or lightweight handrail brackets would also keep you from spreading them out too much.