29.9565
As of my last update in October 2023, the cost of R22 freon typically ranged from $30 to $50 per pound, depending on market conditions and availability. Prices may vary based on location and supplier. Additionally, due to the phasedown of R22 under environmental regulations, costs can fluctuate significantly. For the most accurate and current pricing, it is advisable to check with local HVAC suppliers or contractors.
V = 1/3πh ( R12 + R22 + R1R2 )where π is 3.14159265..., and R1, R2 are the radii of the two bases.
Lateral Surface Area = π(r1 + r2)s = π(r1 + r2)√((r1 - r2)2 + h2)Top Surface Area = πr12Base Surface Area = πr22Total Surface Area = π(r12 + r22 + (r1 * r2) * s) = π[ r12 + r22 + (r1 * r2) * √((r1 - r2)2 + h2) ]
For a conical frustum:Lateral Surface Area = π(r1 + r2)s = π(r1 + r2)√((r1 - r2)2 + h2)Top Surface Area = πr12Base Surface Area = πr22Total Surface Area = π(r12 + r22 + (r1 * r2) * s) = π[ r12 + r22 + (r1 * r2) * √((r1 - r2)2 + h2) ]
R-12..........
No
407C is a refrigerant that is often used as a replacement for R22, particularly in systems designed for R22. While it is compatible in terms of functioning within the same system, it is important to note that 407C operates at slightly different pressures and requires a different oil type (POE oil instead of mineral oil). Therefore, a system designed for R22 may need some modifications to ensure optimal performance with 407C. Always consult a professional before making any changes to refrigerant types in HVAC systems.
I think that it's olive oil, but I/m not sure
no. it is not a good idea. new hfc refrigerants require a different type of oil than the R22 units. the new refrigerants typically run at higher pressures than the R22 units.
To convert an HVAC system from R22 to R410a using a conversion kit, the process typically involves recovering the existing R22 refrigerant, replacing the compressor oil with a compatible oil for R410a, installing a new filter drier, flushing the system to remove any remaining R22, and then charging the system with the new R410a refrigerant. It is important to follow manufacturer guidelines and consult with a professional HVAC technician to ensure proper conversion and system performance.
There are different types of refrigerant oils. Refrigerants such as R22 and R12 usually use mineral oil. But some of blended refrigerants like R410A can sometimes use a poly oil. These oils can not be blended together. So a system that already has a refrigerant with mineral oil must be charged with refrigerants with the same oil.
if the timing chain and tensioners are worn out the chain will wear a hole in the timing cover and the oil will get into the water jacket and the antifreeze will get into the oil high time to fix it
Wal-Mart do not have r22 freon, this is a false ad.
Your AC won't work any better than it did before. Two very different refrigerants, which will not blend, with different superheat points and system pressures. Not to mention that R22 won't carry PAG oil through the system as effectively as 134a, meaning you could end up starving your compressor of lubricating oil, thus burning it out.
r22a
No