There are 7 syllables. You - see - the - leaves - blow-ing - off.
Lines that extend off the object to show what is being dimensioned
Line, line segment, point, skew lines, intersecting lines, perpendicular lines, that's the ones that i can think of off the top of my head
If it is equipped with sport mode, then there is a switch down by your right knee that turns it on and off.
lines go infinitely in both directions of the line line segments are just a part of the lines rays start at one point and go off into the other direction infinitely
hi guys first you take off the intercooler and nessary lines connecting it remove down pipe remove oil and water lines (usually a 17 socket) unbolt the housing for the turbo (three 14 bolts)
I have a 2006 Chevrolet C4500 Duramax Diesel and I would like to know how to turn off or reset the check engine light on the truck.
for me it wasnt that hard however, you have to be good at blowing well (hard but not too much) and able to read high notes (the ones off the lines, way off)
Can you remove the bottom drain shut off valve and still blow out a plug the bottom drain on your pool.
ok well in my twin turbo you would just have to take the water lines off the back and reach under the intake manifold on the back side, {if you have enough room}
Some turbo cars will be fitted with a turbo timer, which keeps the engine running for a specified time after the ignition is turned off. This allows the turbo to cool down before the engine shuts off, which prevents potential damage to the turbo.
I do not see the point in doing it but it would be a lot of work. it would be just like turbo charging a non-turbo car, running all the lines and all. also the engine in that car is weak. get a GST/GSX all ready turboed and has the 4g63 Actually, Depending if you have the DOHC (Dual Overhead Cam) model or not you may be able to do a direct bolt on of the turbo system off a vehicle with the same engine. But I recommend getting your turbo off of an eclipse GS Turbo or GSX because all the lines and the manifold and everything will already fit without any modifications. Getting it off of a laser would work, but not as well as would require many modifications to make it fit/work.
You mean the outside unit is running and blowing but the inside unit is not blowing? Shut it off! Who ain't blowing? Elaborate please..
Amazingly pointless. The blow off valve is there to release intake pressure if you have the turbo spinning and then go off the throttle suddenly. If you haven't got a turbo there's no intake pressure to release if you go off the throttle.
because he just is
uh huh.
That will vary depending on what engine the turbo is off of.