Technically, yes. But, the equations involved are complicated to the point that it would be a fraction of the difficulty of converting. Also, the equations are essentially the Cartesian equations with the conversions built in, so you might as well convert them to start with.
However, if you insist on not converting, write out the entire process with all 4 points of interest in Cartesian coordinates. From beginning to end. Find the final equations needed and insert the conversion factors and simplify from there. To the best of my knowledge (and I did quite a bit of digging) there isn't a simply way of doing it. - Sorry.
Cartesian coordinates are named after French mathematician Rene Descartes, who lived in the early 1600s & developed many modern conventions of mathematical notation.
758,200,003 in Scientific Notation = 7.58200003 x 108
(x,y,z)
(x,y,z)
Yes. This is the basis of cartesian vector notation. With cartesian coordinates, vectors in 2D are represented by two vectors, those in 3D are represented by three. Vectors are generally represented by three vectors, but even if the vector was not in an axial plane, it would be possible to represent the vector as the sum of two vectors at right angles to eachother.
Cartesian coordinates are named after French mathematician Rene Descartes, who lived in the early 1600s & developed many modern conventions of mathematical notation.
The answer depends on what specific notation you have in mind.
758,200,003 in Scientific Notation = 7.58200003 x 108
(x,y,z)
(x,y,z)
(x,y,z)
240.185.8.103
The primary person involved in describing the concept of the Cartesian plane and the notation for ordered pairs was the French mathematician, Rene Des Cartes. See the related link.
Yes. This is the basis of cartesian vector notation. With cartesian coordinates, vectors in 2D are represented by two vectors, those in 3D are represented by three. Vectors are generally represented by three vectors, but even if the vector was not in an axial plane, it would be possible to represent the vector as the sum of two vectors at right angles to eachother.
In notation of coordinates it is the x axis followed by the y axis
to convert scientific notation to decimal you count the number of spaces up to the last digit then put the decimal point then put x10 to the power of if how many places you move the decimal point.................................
A point is named by a pair of real numbers. The standard notation is to put a comma between them and parentheses around them like (1.2, -2) .