Wiki User
β 13y agoYou can't. In every engine, even an ideal engine, the output is less than the input. And every real-life engine loses energy to friction, heat, etc. So you'll always have an engine that's less than ideally efficient, and therefore putting out less than you put in.
Wiki User
β 13y agomore input results in more output the function is most likely directly proportional
multiplexer
The output is 1 more than 10 times the input.
It is a relationship from one set to another, which is not a function.
Efficiency as a percent is output/input * 100%12000/15000 * 100% = 80% efficiency which makes sense, because it takes more work (input) than it give out (output). So the efficiency should be less than 100%.
input
An inverter has a high output when the input is low, and a low output when the input is high.
~the function is most likely inversely proportional. ~more input results in less output.
Depends on the size & rating of the battery and alternator. Tested & replaced one for a friend a while ago... his bike a `93 1100ViragoXV. That had a 12v battery and the regulator was outputting around 13.2v. Output should be slightly more than batteries output, input is irrelevant if your alternator is kicking out as it should. Suggest you find a workshop manual for the bike or contact the manufacturer of the regulator for exact specs.
An output force is the force that is exerted from the input force to create motion of the resisting object. the input force can be less or more then the output force
An output force is the force that is exerted from the input force to create motion of the resisting object. the input force can be less or more then the output force
more input results in more output the function is most likely directly proportional
No. A function has only one output per input.
Neither. It is simply a container for the more fragile components.
Input energy is typically more useful than output energy because input energy is the initial energy put into a system to produce the desired output. Output energy, on the other hand, is the energy produced by the system after losses and inefficiencies have occurred, so it is usually less than the input energy. By maximizing input energy efficiency, we can achieve a more effective output.
The relationship between work input and work output is defined by the efficiency of a system. Efficiency is a measure of how well a system converts input work into output work and is calculated as the ratio of output work to input work. A higher efficiency indicates a more effective conversion of work input to work output.
A table in which you put in a number and out comes another number. Usually more than one groups of numbers. And almost ALWAYS follows a rule such as: Input x3=Output or Input -23= Output Input | Output 2 | 4 10 | 20 16 | 32 In this table you can see that the rule is Input x2 = Output Hope This helped!