How do you change the aerial base on a 2000 206?

Answer 1

Firstly you need to remove the interior light.

To do this you need to slide a thin flat head screwdriver into the groove on the right hand side of the light (clear plastic end not the switch end) then pull the screw driver handle towards you slowly, this should prize the light away from its surround and it should then fall out.

Once the light has dropped down you will need to remove the bulb housing that is attached to the wires from the clear plastic and switch, this can be done by squeezing the sides of the light grey plastic clip attached to the bulb and sliding it out.

Now you need to remove the plastic surround of the interior light.

To do this you need to put both your index fingers up inside the surround to feel to curved clips these need to be pushed towards the rear of the car and the surround should come free.

Now you should see a metal shiny disc that you need to remove to reveal the bolt for the aerial base you can do this with the same flat head screw driver as used to remove the interior light.

You will then see a small bolt which needs to be undone to remove the aerial base, this can be done using a ratchet and an 8mm bit.