For this, you can work out the volume of the cylinder of sand you need to fill. But you'll also need to know the density of the sand to convert this volume into weight.
You cannot. Cubic feet per second is a flow rate measured in terms of volume, while tons per hour is a measure of flow rate in terms of mass. Volume and mass are two different measures and according to basic dimensional analysis, conversion from one to the other is not valid.
3096 sq yds by 9 in thick is a volume of 774 sq yards.To convert that to a weight in tons, multiple it by the density of the substance in tons per square yard.
1 tons / 1000 = kg
You have to know the density of the material before you can convert its volume into weight. The volume is 110 x 13 x 0.25 = 357.50 cu.ft. 357.5 cu.ft. x density in pounds per cu.ft. = weight in pounds. After that you convert the weight in pounds into tons. If, say the material is a concrete slab, then the aproximate density would be 140 pounds/cu.ft and the weight will be 357.5 x 140 = 50050 pounds = 25 short tons (1 short ton = 2000 pounds).
30 tons to liters You can't convert - tonnes measure weight (mass), litres measure volume.
you cannot convert mass into volume....
How to convert cubic meters to tons of armour rock with 2.7 specific
You don't. Cubic yards is volume while yards is distance.
By multiplying it by the density of the substance (expressed in tonne/m3) that occupies the volume of 1000m3.
For this, you can work out the volume of the cylinder of sand you need to fill. But you'll also need to know the density of the sand to convert this volume into weight.
Cannot be done because tonnes are units of mass or weight, and litres are units of volume.
You can't, unless you know what the material is. 1000 gallons of gasoline will weigh less than 1000 gallons of water, which will weigh less than 1000 gallons of mercury. Unless you know the density of the stuff, you can't figure out how much a given volume of it will weigh.
To measure tons of gravel in a stockpile, you can use the formula for volume calculation by taking length x width x height. Then, you can convert the volume to weight by multiplying it by the density of gravel, typically around 1.5 tons per cubic yard. This will give you an estimated weight of gravel in the stockpile in tons.
To convert ethanol liters to tons, you need to know the density of ethanol. The density of ethanol is about 0.789 kg/L. To convert kilograms to tons, divide by 1000. So, to convert ethanol liters to tons, you would multiply the volume in liters by 0.789 (density of ethanol) and then divide the result by 1000.
A liter is a measurement of volume. A ton is a measurement of weight. You cannot convert directly between the 2.
To convert NM3 (normal cubic meters) to metric tons, you need to know the density of the gas. Once you have the density, you can multiply the volume in NM3 by the density to get the mass in metric tons. The formula is: Mass (metric ton) = Volume (NM3) x Density (metric ton/NM3).