a line used to mark the outside of an object
Use a ruler to measure the line (horizontal?) and mark the middle of the line, then use a right-angle triangle to draw a vertical line 90 degrees from the mark. Or you can use a compass fitted with a pencil to draw arcs that will give the middle mark and a mark to line a ruler against to draw the perpendicular line required. Search Google for using a compass.
A mark, or a stroke.
they red line at 6 grand. but you can take your computer to a specialest and they can program it to red line at 10 grand
You need a compass, the little protractor-like device for scribing a circle, and a straightedge. First you draw a straight line. Then, you mark where you want the two lines to cross. You take the compass, put the point on the mark, and swing the compass, making two marks on the line, equidistant from the first mark (the future intersection). Then, you open up the compass a little wider than it was, put the point on one of the second marks, and swing another circle in the area perpendicular to the line. Carefully maintaining this current opening on the compass, pick it up, put the point on the remaining second mark, and swing an arc that intersects the line(s) you just made. You should now have a straight line with two intersecting arcs beside it. Take a straightedge and line up the intersecting points on the arcs. It should go right through the first mark you made on the line. Scribe the line. You now have two lines that meet at right angles. You can also make one with a right triangle. First you draw a straight line. Then you mark where you want the lines to cross. Then you turn the triangle and put the outside point of the 90° angle up against the point on the line, with one side of the triangle flat against the line. Holding the triangle firmly against the paper, draw part of the intersecting line using the edge of the triangle that's pointed away from and perpendicular to the line. Turn the triangle so that the hypotenuse is lined up with the line you just made and also crosses the first line. Scribe the line. You now have two lines that meet at right angles.
true
Red Line mark-ups are when you take construction drawings and confirm them during insatallation and commissioning. Changes are marked in red.
Line the mark on the crank pulley up with the mark on the timing cover, and line the distributor rotor up with the mark on the pickup plate.
Line up mark on crankshaft damper with 0 mark on timing cover. Line up distributor rotor with line on pick up plate .The final timing is set by a using scan tool to sync the distributor to the cam sensor at 0 degrees.Line up mark on crankshaft damper with 0 mark on timing cover. Line up distributor rotor with line on pick up plate .The final timing is set by a using scan tool to sync the distributor to the cam sensor at 0 degrees.
Line up the timing marks on both camshaft sprockets so that they face each other. And line up the crankshaft pulley mark with the mark on the engine block.
No. A red wavy line will appear underneath it.
The timing mark is a line that goes across the harmonic balancer that should line up with the mark on the timing chain cover. It is on the drivers side on the bottom of the timing cover.
See a doctor.
they put a red out line around it
Mark Twain's hair color is red, although it does not show up in black and white pictures.
pin the engine on the flywheel. line the timing mark on the cam gear with the timing mark located on the timing cover. the mark on the cover is located at the top and is just a bump formed in the cover.
Set your strings up at one corner. Use the corner as a start point. From that corner measure out 3 feet and make a mark on the line. Next, on the other line measure out 4 feet and make a mark. Hold the end of your tape measure at one of the marks. Now have some one move the far end of the other string in and out until you line up the mark at 5 feet from the other mark. When you have a diagonal line of 5 feet from mark to mark, your corner will be square. You can now just measure from the lines that are now square to set the other lines.