answersLogoWhite

0

Everything the same as when only setting up one, however the drain farthest away from where the two meed the drain line must be slightly higher (1/4 inch high per foot of distance to the other drain (or more)and you will have two vent pipes (one from each) that can be tied together and sent out through the roof. Also don't forget you need two traps (one for each right under the drains).

User Avatar

Wiki User

19y ago

What else can I help you with?

Continue Learning about Math & Arithmetic

Dose a positive pressure drain need a trap?

A trap on a positive drain is used to avoid the 'contaminated' air in a HVAC system from traveling through the condensate line and entering into areas where it is unwanted. The trap becomes necessary when one condensate line is used for multiple units, especially if it is tied to other negative pressure drain traps. The negative pressure drain traps may not drain properly if they have to overcome the positive non- trapped pressure of another unit. It allows the condensate to drain more evenly, as well. Without a trap, the positive pressure from the unit can blow air through the drain with the water and cause 'spitting.' A trap on a positive pressure system may not always be necessary, but it is good practice to trap every drain and trap it properly. There are guidelines for both positive and negative pressure traps. Always follow the manufacturers recommendations.


It takes Sal 5 hours to paint a house It takes Sal 3 hours to paint the same house How long will it take to paint the house if both of them work together?

It would take them 4 hours to paint the house together.


It takes Samantha 4 hours to clean her house Her husband Patrick can clean the house in 7 hours How long would it take both of them to clean the house?

2.54545454 or 2 6/11 hours.


If it takes a person 5 hours to wash a house and another person 3 hours how long does it take them to both wash the house together?

Less than two hours.


Does square footage of a house include both floors?

The square footage of a house includes the entire area that is heated or cooled. If it has an attic, basement, or garage that is not heated and not lived in, those are mentioned separately.

Related Questions

What is a shower roughen?

A shower rough-in usually refers to the distance from the wall to the center of the shower drain , measured out away from both walls in a shower to the center of the drain. It also maybe referring to the height and the center line of the placement of the shower valve.


How reliable is a house with a wood foundation?

How reliable a house is with a wood foundation depends. The type of lumber used and whether it was treated both play a role. If you are considering buying a house with a wood foundation, make sure you have it inspected.


Can you add a shower drain to a tub drain or does it need its own waste and vent line?

It's best to have a separate waste and vent line for a shower drain. Introducing a shower drain to a tub drain without a separate line can lead to drainage issues and potentially cause backups or slow draining in the system. It's important for each fixture to have its own dedicated waste and vent line to ensure proper drainage and venting.


What is the best way to prevent basement flooding: installing a sump pump, a French drain, or both?

The best way to prevent basement flooding is to install both a sump pump and a French drain. A sump pump helps remove water that accumulates in the basement, while a French drain helps to redirect water away from the foundation of the house. Together, they provide a comprehensive solution to prevent basement flooding.


What is the best type of mortar to use for a shower installation?

The best type of mortar to use for a shower installation is a polymer-modified thinset mortar. This type of mortar is specifically designed to bond well with both the shower pan and the tiles, providing a strong and durable foundation for the shower walls and floor.


Why would a toilet back up into the shower?

A down line clog would cause this. The shower drain is lower than any other drain in the bathroom so it is the first to tell you of a clog in the line. Time to Roto Rooter! Y-THINK-Y The toilet and shower must have the same drain. There is a blockage somewhere after the toilet and shower drains meet. The backup takes the easiest route back which must be the shower drain. Try snaking out both drains. Start with the toilet. To do the best job, remove the toilet and start from floor level.


Why are both the shower and toilet not draining properly?

The shower and toilet may not be draining properly due to a clog in the plumbing system that is affecting both fixtures. This could be caused by a blockage in the main drain line or a problem with the venting system. It is important to address this issue promptly to prevent further damage and ensure proper drainage.


Bridal shower or engagement party. one or both?

Bridal shower is mainly for the bride while the engagement party is mainly for both. Go with a Shower Dance, both sexes can attend :)


Which is more correct take a shower or have a shower?

To take a shower is US English; to have a shower is UK English.So they are both correct.


What could a dribbling noise be that you hear from the main floor ceiling after flushing the toilet or during the shower if there is no sign of water leakage under the toilet or shower?

If the toilet and shower are in an upper floor then there is a PVC drain for both that will drain to either the sewer or septic. If there is a vertical piece to this, as there is in my basement, then you actually get some dribbling and running sounds from the water 'falling' down that vertical PVC. I get this same noise from the washing machine on the main floor draining down to the basement.


What are the features of the master bath, including the presence of both a tub and a shower?

The master bath features both a tub and a shower.


Why does water still come out of the faucet when using the shower?

Water continues to come out of the faucet when using the shower because the plumbing system in a house is designed to supply water to multiple outlets simultaneously. This means that water can flow to both the faucet and the shower at the same time without any interruption.