answersLogoWhite

0

What else can I help you with?

Related Questions

What is the miter cut for a 45 degree elbow?

30


What is the distance between 45 degrees north and 45 degrees 30 minutes north?

The distance between 45 degrees and 45 degrees 30 minutes north is half a degree or 30 nautical miles.


How do you mitre a trim around an octagon?

At each vertex, the mitre needs to turn the trim through 45 degrees. Therefore, at each mitre the outer edge of the trim must be 22.5 degrees (a quarter of a right angle) further out.


A location that is 30 degrees north and 45 degrees west is in the?

the northwest


Do elbow 135 degree and elbow 45 degree are same?

No, elbow 135 degree and elbow 45 degree are different from each other.


What are the symbols for degrees minutes and seconds?

Degrees: ° Minutes: ' Seconds: "


What triangle has the angle measurements of 105 degrees 45 degrees and 30 degrees?

It is an obtuse triangle


What is the recommended angle for installing a 90 degree elbow in the dishwasher's drainage system?

The recommended angle for installing a 90-degree elbow in the dishwasher's drainage system is 45 degrees.


What is a complament angle?

The complement to an angle is how much it takes to make 90 degrees. The complement to 30 degrees is 60 degrees. The complement to 45 degrees is 45 degrees.


A location that is 30 degrees south and 45 degrees east is of the Prime Meridian and of the equator?

A location that is 30 degrees south and 45 degrees east is not on the Prime Meridian but is on the equator. The Prime Meridian is at 0 degrees longitude and runs through Greenwich, England.


How cold is the mediterranian?

30-45 degrees north and south of the equator


What does mean by Elbow 45 butt weld LR?

Elbow is a fitting used to change pipe direction, 45 degrees in this case, LR is referred as "long Radius" ( normally most pipes, unless you ask for SR, short radius). Butt weld refers to welding 2 ends from two separate fittings or pipe. Both ends are beveled (30 degrees is tapered from inside pipe diameter to outside pipe diameter on pipe/fitting connections)