the wheel and axle is a simple machine made from two circular objects and are different sizes that are attached and rotate together and it is a lever that can rotate to 360 degrees
Yes, there are about 16.6 million different colors in the RGB color wheel.
B
That depends on the relative sizes of the gear shafts used to transmit power from the motor to the wheel. For instance, if they were the same size, and no gears in between, then the wheel would rotate 400 times a minute (RPM), which is 6.66 times a second. But usually gears transmit power in such a way that the wheel rotates slower than the motor (less RPM) but with more power.
This is a measure of a car tyre. It is a combination of units and ratios that is enough to drive most people nuts! 175 refers to the width of the tyre (in millimetres) from sidewall to sidewall. 15 refers to the diameter of the wheel rim (in inches). 75 is the ratio (in percent) of the profile to the width. The profile is the length from the wheel rim to the edge of the tyre. I suspect the r means a radial tread but I am not sure about that.
Bike skewers typically come in two sizes: 100mm for the front wheel and 130mm for the rear wheel. These sizes refer to the length of the skewer that attaches the wheel to the bike frame.
There are different sizes for wheelie bins.
No, a 27.5 tube will not fit a 700c wheel as they are different sizes.
The larger the wheel size the easier it is to run over humans
Well, if you have two bikes with the same wheel sizes, going at the same speed, but the pedals going at different rates - then they have different gear ratios. Mosty probably due to having different tooth counts at chain wheels and sprockets.
Two circular objects of different sizes that rotate together is a wheel and axle. Inclined plane wrapped around a central cylinder or bar to form a spiral is a screw.
The most common bicycle wheel axle sizes available in the market are 9mm, 12mm, and 15mm for front wheels, and 10mm and 12mm for rear wheels. These sizes refer to the diameter of the axle that fits through the hub of the wheel.
No, a wheel and axle consists of two different circular pieces of different sizes. The larger circular piece is the wheel in the system, and the smaller circular piece is the axle.
Can't be answered, bike wheels come in many different sizes.
wheel and axel
They came in different sizes, but the radius of the wheel had to be less than the inseam measurement of the rider.
no its a grooved wheel with a rope running along the groove the above answer is wrong because it is the definition of a pulley. Yes that is true. A wheel and axle is a simple machine consisting of two wheels of different sizes that rotate together.