0
What else can I help you with?
When more than one application is running on a server how does IP know which service should be presented a data packet?
The port number lets IP know which service should be presented a data packet.
What is the syllable of packet?
There are two syllables in the word packet pack-et
What statement is true about the TTL value of an IPv4 packet?
it specifies the remaining " life" of the packet
How many number of routes carried by RIP packet?
Up to 25 destinations can be listed in a single RIP packet.
The packet has a mass of 800g and contains 40 fishfingers. How many grams less than 1 kilogram is the packet of fishfingers?
The packet weighs 800 g and is therefore 200 g short of 1kg. The number of fishfingers is irrelevant in your question.
When more than one application is running on a server how does IP know which service should be presented a data packet?
The port number lets IP know which service should be presented a data packet.
When more than one application is running on a server how does IP know which service should be presented an incoming data packet?
When multiple applications are running on a server, the operating system uses ports to distinguish between them. Each application listens on a specific port number, which is part of the transport layer protocol (like TCP or UDP). When an incoming data packet arrives, the server checks the destination port number in the packet's header and forwards the packet to the corresponding application based on that port. This way, the server can effectively route incoming data to the correct service.
How does ip knows which service should be presented a data packet?
By the Port Number.
What is a source port number?
Source Port number is the unique application identification number of the service/application at sender side which sending data to the receiver. Using this source port number the receiver thus can identify which service/application has send this packet and to which application/service the receir should reply to if necessary. -- By MyNarutoAnime ----
What does GPRS stands for?
General Packet Radio Service
What is the primary difference between router packet handling and application packet handling?
idfk
When was General Packet Radio Service created?
General Packet Radio Service was created in 1997.
What packet data use for?
Packet data means internet data service pack.
What is the full meaning of GPRS?
GPRS stands for Ghod pade Rituraj Saxena
Which statement describes the correct use of addresses to deliver an emailmessage from HostB to the email service that is running on serverA?
Router B uses a Layer 3 network address to route the packet.
Abbrivation of gprs?
General PAcket Radio Service.
What is the abbreviation GPRS?
The General Packet Radio Service
