Four tiles are needed.
184.08 square feet is needed.
90 feet squared of carpet is needed.
78 feet!78 feet!78 feet!78 feet!
To determine the amount of fencing needed to cover a rectangular area measuring 28 feet by 26 feet, you can calculate the perimeter. The perimeter (P) is given by the formula P = 2(length + width). In this case, P = 2(28 + 26) = 2(54) = 108 feet. Therefore, 108 feet of fencing is needed.
The number of junction boxes needed in a 300-foot run of conduit depends on several factors, including local electrical codes, the type of installation, and the specific requirements of the electrical system being installed. Generally, junction boxes are installed every 100 feet for long runs to allow for splices and changes in direction. However, additional boxes may be required if there are bends, changes in wire size, or access points needed. It’s best to consult local codes and an electrician for precise requirements.
I always put the first EMT clip/strap 1 foot or 12 inches away from the junction box, then every 5 feet or so after that.
A 100 foot fish tape and wire lubrication will be needed to make this wire pull.
The National Electrical Code (NEC) requires that rigid conduit be strapped or supported at specific intervals to ensure safety and stability. Generally, rigid conduit must be secured within 10 feet of the last coupling or fitting and at least every 10 feet thereafter. Additionally, it should be supported within 3 feet of any outlet box, junction box, or other fittings. Always refer to the latest version of the NEC or local codes for specific requirements.
The 2008 NEC code states that conduit must be strapped within 36" or 3 feet from every box or connector, then every 5 feet is acceptable from there.
Each length of wire needs to be 179 feet long - X 3 = 537 FEET OF WIRE NEEDED.
Lee needed shoes for his army, many of whom were marching in bare feet. It was also a railroad junction from which he could maneuver in any direction.
Grand Junction, Colorado is 4,593 feet (1,397 meters) above sea level
No. The new electrical code change does not allow any flexible conduit to be used as a ground means. It is now required to have a green ground wire pulled into the conduit with the other conductors in the flexible conduit. This grounded bonding conductor is not counted as wire fill when calculating the size of the flexible conduit to use
10 Metres or 32 feet
This is one of those questions that has a lot of answers! In a residence I would want it as short as possible, however you can legally run it 10 feet, if you use steel flex or metallic liquid tite in your raceway system the maximum length of the flex can only be 6 feet with the remaining 4 feet of conduit. Inspectors in some areas like for the service panel located in the first stud bay available nearest the service entrance, this usually keeps the conduit and wire length to a minimum.
Deep inside the jungle far from anywhere there's a place that no one knows but we can take you there its jungle junction jungle junction the jungle junction life is fast and friendly and everyone you meet cruises round on high-speed roads on wheels instead of feet at jungle junction jungle junction