0
Want this question answered?
Be notified when an answer is posted
Add your answer:
Earn +20 pts
How much time would it take to travel 107 miles?
It depends on how fast you travel.
How many hours would it take to travel 1580 km?
It very much depends on the speed at which you travel and that will depend on your mode of transport.
How much concrete does it take to fill 6 inch diameter pipe seven foot long?
Approx 10.3 US gallons.
A ping pong ball falls into a tight deep pipe The pipe was only a bit wider than the ball so you can not use your hand How would you take it out with no damage?
Use a straw to suck that ball Take it out from the other end of the pipe Use some sticky chewing gum on the end of a bit of string, or a cane - also handy for getting screws and things off the floor when you drop them down between things Fill the pipe with water and the ball will float out. Turn the pipe upside down Answer Use a vacume cleaner.
How much time will it take to travel 345 miles at 60 mph?
5 hours 45 minutes.
Why does it take ten minutes for the hot water to travel the last 18 inches to your bathroom tap?
Sounds like you have galvanized pipe. Over time deposits, or scale, build up inside these pipes from the minerals present in all tapwater. This build-up narrows the diameter of the pipe to a very few millimeters, thereby restricting water flow. The best solution for this is to re-pipe, as much as you can, with copper piping. Copper does not have a problem with scaling. If that's too expensive re-pipe with galvanized pipe. One way or another, you'll need to do some re-piping to improve your water flow.
How many gallons of water would it take to fill 125 feet of 12 inch pipe?
It would require 2,937.6 US gallons of water to fill the pipe.
How much more pressure does it take to push water up a vertical pipe than if the pipe is on a 45 degree angle?
it takes the same pressure if the vertical heights the same but since the 45 degree pipe would be longer it would create more flow restriction.
How many feet of 8 pipe will it take to hold 150 gallons of water?
An 8-inch pipe must be 57.4 feet long to contain 150 gallons of water.
How much PSI does it take to push one gallon of water through a one half inch pipe?
That would also depend on the length of the pipe, and on how fast you want the water to move. If you are in no hurry, even the slightest pressure will be enough to push the water through the pipe.That would also depend on the length of the pipe, and on how fast you want the water to move. If you are in no hurry, even the slightest pressure will be enough to push the water through the pipe.That would also depend on the length of the pipe, and on how fast you want the water to move. If you are in no hurry, even the slightest pressure will be enough to push the water through the pipe.That would also depend on the length of the pipe, and on how fast you want the water to move. If you are in no hurry, even the slightest pressure will be enough to push the water through the pipe.
What is the hottest water a plastic PVC pipe can withstand?
PVC can take hot water like any other pipe but the reason no one wants to use it on hot water lines is because the glue joints can not take hot water so if your talking about straight pipe then it will be ale to take 212 degrees but if your talking about pipe and glue joints then it will fail around 65 + degrees F . If you want to run hot water in PVC you can use CPVC and the glue joints an pipe can with strand 212 degrees F but after some years as I have seen the pipe gets real brittle and so i always recommend the best called Wirsbo or any class AA pex
Water capacity of 2 X 500' of water pipe?
The water capacity of two 500' water pipes will depend on the pipe diameter. Typically, water pipe capacity is measured in gallons per minute (GPM) or liters per minute. The larger the diameter of the pipe, the higher the water capacity it can handle.
How much time does it take to travel 15 miles?
It depends on how fast you travel.
Why does it take 90 seconds to get hot water from tank to faucet?
That's just how long it takes to get the water that is sitting in the pipe out. Unless you have a circulating pump on the line so that there is always hot water at the faucet, it always takes a bit of time for the water to get hot. The hot water is in the tank, not the pipe connecting it to the faucet. There is nothing in the pipe to keep the water hot.
How do you deal with an electrified water pipe if you cannot access the miswired part?
You have to find and correct! If the water pipe is electrified, Then connect a volt meter from the water pipe to ground, and measure the voltage. Now turn circuits off one at a time Until you find the circuit that is energizing the piping, and take it from their..
How many feet of 3 pipe will it take to hold 3 gallons of water?
14 feet
Do you have to lower or take petrol tank off to replace a fuel pipe on a peugeot 306?
It is possible to replace by lowering tank and warming pipe in hot water.
