answersLogoWhite

0

A residential boiler typically holds between 20 to 80 gallons of water, depending on its size and type. Smaller boilers may hold around 20-30 gallons, while larger models designed for bigger homes can hold up to 80 gallons or more. The exact capacity can vary based on the manufacturer's specifications and the heating system's design.

User Avatar

AnswerBot

2w ago

What else can I help you with?

Related Questions

How much should you pay a plumber to install a boiler and water heater?

Labor alone for a residential boiler would be around $800 while a water heater would be around $210-$300. These are typical rates for Connecticut anyway.


What is boiler combustion efficiency?

boiler efficiency is how much water is converting to steam.


How many watts does a house boiler use?

The wattage of a house boiler can vary depending on its size and efficiency. On average, a typical residential boiler can use anywhere from 1,000 to 5,000 watts when operating. It's best to check the specific model and technical specifications of your boiler for an accurate wattage measurement.


How much water can a shaduf hold?

I can hold 20 liters of water.


How much water do regular teaspoons hold?

They hold 5ml of water.


How much water does a jacuzzi hold?

My jacuzzi 370 hot tub how much water doae it hold?


What is the Cost to replace hot water gasket valve on boiler?

It will cost about $60.00 to replace a hot water gasket valve on a boiler. This is if you do it yourself. If you hire a professional, they will charge you for labor and the ending cost will be much more.


How much water does a 4.0 1995 explorer hold?

It doesn't hold any water.


Difference between fire tube boiler and water tube boiler?

The difference between the two is that the Water tube boilers are safer and last much longer than the fire tube boiler. Their size is also larger and have a faster recovery time. However fire tube boilers have a low cost.


Can you incorporate a solid fuel back boiler into a pressure water system it would be nice not to have to use so much oil and take advatage of our wood burning stove?

Yes, If it is a pressurized system, the water from the back boiler and your oil or gas fired boiler can be mixed. This can also be achieved by using a water to water plate exchanger to preheat the return water from your heating devices. If you have a forced air heating system in the house, a coil can be placed in the main trunk line of the duct work and heated by circulated water from the back boiler.


Cost of boiler repair in NJ?

Much more information needed. -Is this really a 'boiler' or a hot water heater, what is to repair etc. -Usually if a hot water heater tank is leaking it must be replaced. . . . Give proper information and get a better answer.


How much water can a sponge hold?

the sponge can hold up to about 40 percent of the water from the bowl.