The weight is 75.23 pounds weight.
It depends on the material and the treatment of material that the plys are made of, the thickness of the plywood, the quality of the plys, the number of plys, and the force being exerted on it; tensil, sheer, compressive, flexural
The answer depends on the linear density of the material.
You will need 12.5 sheets of 4x8 plywood.
No, it is treated and manufactured under much higher pressure, free of voids, and will cost even more than exterior plywood, which is costlier than "regular" plywood.Marine plywood is good enough for boat building . But regular plywood can only be used for furniture , decoration .
The amount of weight a half-inch sheet of plywood can hold will depend on the grade and type of plywood, as well as the size of the sheet and how the weight is distributed. As a general guideline, a half-inch sheet of plywood can typically hold between 40-60 pounds per square foot when evenly distributed.
it can hold as much weight as it can handle
The weight of .75 inch plywood varies based on the type of wood used. On average, a sheet of .75 inch softwood plywood weighs about 61 pounds, while a sheet of .75 inch hardwood plywood weighs around 75 pounds.
A three quarter inch plywood trailer floor can typically support a distributed load of about 50-60 pounds per square foot. However, the weight capacity may vary depending on the quality of the plywood used and the design of the trailer.
The weight of treated plywood can vary depending on the type of treatment and thickness of the plywood. On average, a 4'x8' sheet of 3/4" treated plywood can weigh between 60-70 pounds. It's always best to check with the manufacturer for specific weight information.
when asking this question you first need to take into account that plywood comes in different thicknesses therefore weight per particualr thickness of sheet plywood will vary-- in my opinion/ without fact and research / a sheet of 1/2 inch plywood may way about 16 lbs. while a 3/4 inch plywood sheet may way 70 lbs.
245 lbs
The amount of pressure needed to punch through a sheet of plywood in one square inch depends on the thickness and type of plywood. In general, it would require a significant amount of force given the strength and density of plywood materials. Commercial hydraulic presses could exert enough pressure to achieve this, generally ranging from 3000-5000 pounds of force per square inch.
The floor joist must be sound and you must have at least 1 1/4 inches of plywood. Top layer MUST be extior grade (CDX grade for example). This is the minimum. Would much rather see 1/2 inch durarock or hardi-backer over 3/4 inch plywood.
It will be printed with how much weight it can handle on the side of the bar.
sq weight of 1 inch glass * 26 times..
what is the weight of an twenty inch tire