0
To reset the Aquapure 1400, first, turn off the unit and disconnect it from the power source. Wait for about 5-10 minutes before reconnecting it. After reconnecting, turn the unit back on, and check the display to see if it has reset and is functioning normally. If issues persist, consult the user manual for specific troubleshooting steps or reach out to customer support.
What else can I help you with?
What is Jandy AquaPure code 145?
The answer is high salt level.
What is 29 percent of 1400?
29% of 1400= 29% * 1400= 0.29 * 1400= 406
WHAT IS 1.3 OF 1400?
To calculate 1.3 of 1400, you multiply 1400 by 1.3. This results in 1820. Therefore, 1.3 of 1400 is 1820.
What is 35 percent of 1400?
35% of 1400 = 1400*35/100 = 490
What is the answer of 1400 percent?
1400% = 14
What is Jandy aquapure 1400 service code 181?
The Jandy AquaPure 1400 service code 181 indicates a communication error between the AquaPure control panel and the cell. This code typically suggests that the system is unable to read the salt cell's status or there may be an issue with the wiring or connections. To resolve this, check the connections, ensure the cell is clean and functioning properly, and verify that the system is powered correctly. If the issue persists, consulting the user manual or contacting a professional may be necessary.
How do you reset aquapure service codes 172 and 186?
To reset AquaPure service codes 172 and 186, first, turn off the unit and unplug it from the power source. Wait for a few moments, then plug it back in and turn it on. For code 172, press and hold the reset button until the indicator light changes. For code 186, you may need to press the reset button or consult the user manual for specific instructions related to that error code.
What is Jandy AquaPure code 145?
The answer is high salt level.
Jandy aquapure 1400 service code 121?
1. You can download the manual for the system. The manual lists the "possible cause" for code 121 as "Low current in reverse direction to Cell." The corrective action suggested is 1. Clean cell if necessary, and 2. Check DC cord.
What is jandy aquapure error code Jo?
The Jandy Aquapure error code that reads "JO" refers to the device's operation is in Service or Time mode. If your device is not working properly, you should contact the manufacturer for a solution of the address of the nearest service center.
What is Jandy AquaPure code 172?
flow sensor service condition or flow sensor is unplugged
What is Jandy Aquapure error code 120?
Clean your cell with acid if it still gives the code its a bad cell
What is 30 percent of 1400?
30% of 1400= 30% * 1400= 0.3 * 1400= 420420
What is 29 percent of 1400?
29% of 1400= 29% * 1400= 0.29 * 1400= 406
What is sixteen percent of 1400?
16% of 1400 = 16% * 1400 = 0.16 * 1400 = 224
Is 1400 80 percent?
80 percent of 1400 = 1120 80% of 1400 = 80% * 1400 = 80%/100% * 1400 = 1120
What is 1408 rounded to the nearest hundreds?
1400
