0
If you have 1.25ml syringe and need to pull 12.5 mg of bendaryl how much do I draw up?
To determine how much to draw up, you first need to know the concentration of the Benadryl (diphenhydramine) solution you have. For example, if the concentration is 12.5 mg/mL, you would need to draw up 1 mL to get 12.5 mg. If the concentration is different, you can use the formula: volume (mL) = desired dose (mg) / concentration (mg/mL) to calculate the correct amount to draw up.
What else can I help you with?
How much is 15 in a 3 cc syringe?
Too much.
How much is 500 mg in a syringe?
The volume of 500 mg in a syringe depends on the concentration of the substance being measured. For example, if the solution has a concentration of 100 mg/mL, then 500 mg would occupy 5 mL in the syringe. To determine the exact volume, you need to know the specific concentration of the solution.
How much is 1000ml on a u-100 unit syringe?
A U-100 insulin syringe is calibrated for units of insulin, where U-100 means there are 100 units of insulin per milliliter. Therefore, 1000 ml would be equivalent to 100,000 units. However, it's important to note that a U-100 syringe typically holds only 1 ml of liquid, making it impractical for measuring such a large volume.
How much is 120 mg in a syringe?
In a syringe, 120 mg would be equivalent to 0.12 mL if the concentration of the medication is 1 mg/mL. This is calculated by dividing the total amount of medication (120 mg) by the concentration (1 mg/mL). It is important to always double-check calculations and measurements to ensure accurate dosing.
How much electricity does a 20-year-old washer with an electric water heater and electric dryer use per month at 24 loads per month?
This depends upon how much current they draw. Older ones tend to be less efficient and draw more. You will have to check the nameplate to see what the current draw is and add them up. Then Ohm's law and the power conversion formula will have to be used.
You have a 3ml syringe and need to give 0.05cc of insulin How much do i draw up in units?
only use a insulin syringe for insulin. insulin MUST be correct.
Using syringe to draw blood?
A syringe is a great technique for blood drawing! It allows the phlebotomist to control the vacuum, which is good because it is much less traumatic on a patient's vein. A syringe may also be used to obtain blood from a small, or otherwise difficult vein.
How much gear oil do you put in a 2005 yz 125?
125ml
How much is 0.15 in a u-100 syringe?
how much is 0.15 in a 1.0 syringe
How much is .3ml in a 1.875 syringe?
0.3 ml in a 1.875 ml syringe is equal to 16% of the syringe's capacity.
How much is 125 ml in pints?
125mL is about 1/4 pint.
How much 2 stroke do you mix with 5 liters of petrol if the ratio is 40 to 1?
125ml
How much 2 stroke do you mix with 5 liter of petrol for a Yamaha banshee 350?
125ml
If using a tuberculin syringe instead of insulin syringe-how much insulin should i draw up?
When using a tuberculin syringe instead of an insulin syringe, it's important to note the differences in their measurements. A tuberculin syringe is calibrated in tenths of a milliliter (0.1 ml), while an insulin syringe is calibrated in units. To convert units of insulin to milliliters, you need to know the concentration of your insulin (typically 100 units per 1 ml). So, if you need to draw up 10 units of insulin with a tuberculin syringe, you would draw up 0.1 ml of insulin.
What dose a blood test feel like?
Does not hurt much. They will draw a bit of blood with a syringe and put it in a small container. Feels like someone pinching you for a second or two and then it is over.
How much is 15 in a 3 cc syringe?
Too much.
how much is 250 mg in a 3cc syringe?
{
