0
What else can I help you with?
What is the margin of the blade?
The edge of the blade should be called as edge of the blade. But in practice the cutting edge is probably called as margin of the blade. The expert in English language should explain better.
How do you cut inside and outside corners in rain gutter?
i use a compound slide miter saw with a carbide tip blade IF YOU DON'T HAVE A COMPOUND MITRE SAW, OR IF YOU DON'T WANT TO TRASH YOUR BLADE BY CUTTING ALUMINUM WITH IT, YOU CAN CUT THEM BY HAND USING A HACKSAW. YOU WILL NEED TO MAKE A 45 DEGREE ANGLE MARK WITH A PENCIL. USE A SPEED SQUARE/RAFTER SQUARE IF YOU HAVE ONE. THIS CUT DOES NOT HAVE TO BE AS PRECISE AS IF YOU WERE DOING BASEBOARDS IN YOUR HOUSE, THERE'S ROOM FOR SLIGHT ERROR HERE AS THE MITRE STRAP THAT GOES AROUND THE JOINT WILL COVER MINOR FLAWS IN THE CUT. CUTTING WITH A HACKSAW WORKS FINE.
When installing a fan shroud should the entire fan blade be inside the shroud or just half of the blade width?
At least half.
When did Infinity Blade happen?
Infinity Blade happened in 2010.
Is there any game like infinity blade?
Blood & Glory is a free rip-off of Infinity Blade (Not as good). Dark Meadow runs on unreal engine 3 and is similar to Infinity Blade. Infinity Blade 2 is obviously the same thing but better in my opinion.
How are hacksaw blades measured?
how to measure the width of a hacksaw blade
What is the visible difference between a metal cutting hacksaw blade and a wood cutting hacksaw blade?
the wood blade has sharp long teeth and the metal on has small tiny teeth
HOW TO UTILIZE HACKSAW?
A hacksaw is a hardened, toothed blade, fixed into a metal frame that has a handle. The hacksaw is used to cut through metal.
How do you bend conduit?
To bend conduit, you typically use a conduit bender tool or a bending machine. The conduit is placed inside the tool, and then pressure is applied to bend it to the desired angle. It's important to follow the manufacturer's instructions to ensure proper bending and avoid damaging the conduit.
What is the proper manner in which a hacksaw blade should be inserted on a hacksaw frame?
The teeth should point forward, as is the case with most saws.
What are the parts of hacksaw?
The handle, the bow and the blade.
What are the parts of the hacksaw and its uses?
Blade frame, nuts, handle.........
How long will it take to cut toilet tank bolt with hacksaw?
That depends on you, the hacksaw and your patience. You will probably have to use just the blade without the handle to be able to get to the bolt. It should be brass which cuts fairly easily. 1-2 minutes should be enough.
Can a hacksaw cut through handcuffs?
yes if you have the right blade you would need a blade that's cuts steel
How many teeth cut in a inch of fine hacksaw blade?
24 or more
How do you cut half inch metal dowel bar?
With a hacksaw, a power saw with an abrasive blade or a pair of bolt cutters. Hacksaw is probably the easiest, cheapest way.
What hand saw cuts metal?
It is a hacksaw, which is a narrow fine-toothed blade set in a frame.
