0
Want this question answered?
Be notified when an answer is posted
Add your answer:
Earn +20 pts
A diac is equivalent to a?
pair of for layer of SCRS
What is the functioning procedure of full wave rectifier by using SCRs?
"What is the functioning procedure of full wave rectifier by using SCRs?" "What is the functioning procedure of full wave rectifier by using SCRs?"
Can SCR be replaced by TRIAC?
Yes since the SCRs act as the real thyristors
What is SCRS..?
A SCR is a Silcon Controlled Recifier. It is a four layer device that can be conceptually considered to be two transistors in latch up configuration. (Though not exactly) For an SCR, there will be no conduction between anode and cathode until the gate / cathode junction is biased on. At that point, the SCR will latch up and conduct from anode to cathode, regardless of further changes on the gate. This condition will persist until the anode / cathode voltage drops to zero. The SCR can be used as a half wave dimmer in an AC circuit. If you want full wave operation, you need to use a bridge rectifier around the SCR, or use a TRIAC/DIAC circuit.
What is static frequency converter?
Static Frequency converter is a static device with power electronic component such as scrs etc
Why SCRs are connected in parallel?
When the load current exceeds the SCR current rating, SCRs are connected in parallel to share the load current. Further the holding currents of the devices should not be so much different that at reduced load current one of the device gets turned-off because of fall of current through it blow its holding current value.
Can you move out when you are 17 in South Carolina?
The state's legal age of majority is eighteen (18), SCRS: Title 20, Chapter 7, Article 1. http://www.leg.state.sc.us
What is the difference between a transistor and scr?
SCR or Silicon Controlled Rectifiers are Bipolar junctions Transistor ( Thyristor Family), SCRs are made of two transistors thats why they PNPN or NPNP devices. The three important parts of transistor are - Emitter, Collector & Base. & the Three Important parts of SCR are - Anode, Cathode & Gate. Use of SCRs- rectification of high power AC & power control applications, such as lamp dimming, regulators and motor control. Use of Transistors - switch, audio, high voltage, amplifiers, switcher
Why are SCRs connected in series?
they are not always connected in series, yes most are for circuit amplification purposes, but some SCR's are just used as an electronic switch by themselves. An example is copier circuits, they use alot of them in single use applications.
Is scr is necessary for speed control of a motor?
Most motor speed controllers have all the power that goes to the motor go through a SCR (usually a TRIAC). If you remove the SCR from such a system, no power will get to the motor and nothing will move -- the SCR is a necessary, critical part. However, many motor speed controllers -- in particular, most variable-frequency drives (VFD), also called inverter drives, typically use some other component to transfer power to the motor -- usually MOSFETs in low-voltage systems and IGBTs in higher-voltage systems. They don't use any SCRs, and so SCRs are not absolutely necessary for motor speed control.
What are advantage of silicon control rectifier?
the big advantage is they are very low costthe big disadvantage is they can't be turned OFF
What is the difference between an SCR and a TRIAC?
A thyristor is another name for an SCR, which stands for Silicon Controlled Rectifier.Thyristors or SCRs are bi-directional devices used to control the flow of AC current. Once triggered, the device remains "on" until the next wave of current crosses zero after the trigger is removed.For more information about thyristors or SCRs see the Related link shown below.
