You can completely specify a circle in a plane by giving the coordinates of its center point, and the length of the radius.
The center of a circle is the point from which all points on the circle are equidistant.
The point from which the circle is drawn IS the center.
No, not all chords of a circle pass though the center of that circle. Any cord that does pass through the center of the circle is called diameter of that circle.
The center of a wheel or circle is called a hub.
A circle is named by it's center point. For instance, let's say you have a circle, complete with chords, radii, a central angle, a center point, etc., etc. We'll say the central point is named "R." Therefore, your circle is named "Circle R."
Center. For example, if the point in the center of the circle was point O, then the circle would be named circle O.
It can be, unless there are concentric circles.
You can completely specify a circle in a plane by giving the coordinates of its center point, and the length of the radius.
True.
It is typically named using one point, which is the center. Sometimes, a circle could be referred to "a circle with diameter AB" in which two points are named. However, you need three non-collinear points to uniquely determine a circle.
Not true because only the largest chord passes through the center of a circle which is its diameter
No. Every circle on the sphere whose center is also the center of the sphere is a great circle. If the circle's center is not also the center of the sphere, then the circle is a small circle.
A RADIUS connects the center of a circle to any point on the circle.
A chord of a circle that contains the center of the circle is called the diameter.
The line from the center of a circle to a point on the circle is the radius.
The center of a circle is the point from which all points on the circle are equidistant.