0
Yes.
What else can I help you with?
Can you get T-T-T diagram of EN8?
NO because the EN8 = A B C D E F G God you should know that
Is 23.504 and 23.50 equivalent or not equivalent?
No, they are not equivalent!
What is the address of Barclays branch with sort code 20-76-89?
The Barclays branch with sort code 20-76-89 is located at 1-3 High Street, Waltham Cross, EN8 7EA, United Kingdom. For the most accurate and up-to-date information, it's best to verify directly with Barclays or through their official website.
What is the difference between a cubic decimetre and a liter?
They are equivalent measures.They are equivalent measures.They are equivalent measures.They are equivalent measures.
What is equivalent to 12 over 16?
120/160 is equivalent.120/160 is equivalent.120/160 is equivalent.120/160 is equivalent.
Is c45 is equivalent to en8?
Yes.
What is the maxhardness acheived in En8 material after heattreatment?
what is the normal hardness of en8 material
What is difference between die steel and en31?
the equivalent for c45 is en-8 and en-19 is c55 Need the Chemical composition and mechanical properties of C45 and EN-8 also to C55 and EN-19
What is the magnetic permeability values of En8 steel and iron powder?
what is magnetic ppermeability of EN8
What is hardness of en8?
The hardness of EN8 is usually between 500 N/mm2 and 800 N/mm2.
Is it possible to magnetise en8?
Yes, it is possible to magnetize EN8 steel. EN8 is a low carbon steel with good magnetic properties that can be magnetized through induction with a strong enough magnetic field.
What is density of EN8?
The density of EN8 steel is approximately 7.85 g/cm^3.
Can you get T-T-T diagram of EN8?
NO because the EN8 = A B C D E F G God you should know that
Can you get EN8 Hardness 170-220BHN?
Yes
What is the difference between en8 and en24?
En8 is low carbon steel and it can be toughned. En24 is medium carbon steel and it is generally called forged steel.
In EN8 material what does EN specifies?
european norms
What is the use of En8 steel?
En 8 is used for manufacturing threaded parts. because hardness of En8 never goes above appr. 30-35 HRC
