huh?
yes i think
Tessellations are are shapes being put together by fitting them in with each other example a honey comb is a tesselation. Anyway constuction workers could use Tessellations by using tiles for a floor or wall
Perimeter Measures the outside of the shape Area Area measures the inside of the shape Both Measurements that describe the shape
If your tiles are 12 by 12 that means they are 1 foot by 1 foot. Say you take 10 and put them in a row that means you will have 10 square feet Area=Length x width (1X10).
The hypocaust was an underfloor heating system for heating houses and the baths using hot air. The floor was raised above the ground by pillars which left a space inside that was filled with hot air from a furnace. The heat from the underfloor heated the air in the room. Passages boxed by ceramic tiles were put inside the walls to move the air to flues on the roof and to heat the walls.
Floor tiles are tiles made for use on a floor. They can be made of ceramic, terra-cotta, linoleum, vinyl and other materials. Ceramic tiles are a type of tile made from hardened materials (like clay). People put ceramic tiles everywhere - around the bathroom, kitchen, pools, etc.
If you will use it inside the house then it's ok, but if you will use it inside the bathroom it is not advisable because wall tiles are slippery when wet. Slippery floroing is not good in the bathroom. It can cause accidents. Simpley put - NO. wall tiles are frequently thinner than flooring tiles and have a surface designed to allow water to stay on the surface. Floor tiles have a degree of grip to prevent slipping. GOOD Trades people will not put these down on floors
Probably, it depends on how thick the tiles are. But after awhile they will crack from the weight put on it.
That would depend on whether they are ceramic tiles or more vinyl tiles.
yes i think
First you have to pull up the old flooring. Once you have the old flooring up you have to put the tile glue on the floor, and place the tile on top of it. Then you have to grout in between each of the tiles. When you get to the edges you will have to cut the tiles to fit.
The smell from Teravertine tiles in a bathroom is probably not the smell from the tiles, but from the adhesive used. This smell should go away with time. The fact that it is in a small space such as a bathroom may make it take longer to go away. Open a window and run a fan for a few days if possible.
Having tiles untold bathrooms I always do the floor LAST this saves dropping tiles etc on to the nice new expensive tile. However, when tiling the walls first leave out the bottom row of wall tile (here you can place your straight edge datum, put in the floor tile then set that last row of wall tile and leave a 1/8" gap between the floor and wall tiles and fill with same water proof grout as the floor tiles have
Its not ideal but if you overboard the existing tiles with hardboard or similar to remove the uneven surface you would get caused by the grout joints you should be ok
To tile a bathroom, you must first find the center of the floor or wall. This is where you will lay your first tile. You work out from there. This way you have the cuts where they are less noticeable. Use a trowel to place tile glue on the tiles, put them in place. Use spacers to keep them apart at an equal distance. Use a tile cutter to cut tiles in areas where a whole tile is not needed. Once you are done, remove the spacers and use a trowel to grout between the tiles. Wipe away excess grout with a wet sponge.
yes you can but remember it is not designed for excessive or standing water contact.
Yes, you can put tile on drywall for a bathroom renovation project, but it is recommended to use a moisture-resistant drywall or a cement backer board to prevent water damage and ensure the tiles adhere properly.