The words depart and remain are antonyms. They have opposite meaning. If you depart, you did not remain. If you remain, you did not depart.
To determine the pressure at the top and bottom of a 6-meter high column of fluid pressurized by a pump to 2 bar, we need to consider the hydrostatic pressure due to the height of the fluid column. The pressure at the bottom of the column will be the pump pressure plus the hydrostatic pressure, while the pressure at the top will be just the pump pressure. Assuming the fluid has a density of about 1000 kg/m³, the hydrostatic pressure at 6 meters is approximately 0.6 bar (using the formula ( P = \rho g h )). Therefore, the pressure at the bottom will be around 2.6 bar, and at the top, it will remain at 2 bar.
In a four-quarter moving average for an annual time series, three quarters would be lost. This occurs because the moving average requires four quarters of data to calculate the first average, leaving only one quarter of the annual time series to be represented. Therefore, only the last quarter of the year would remain after applying the moving average to the entire data set.
yes. If the forces acting on the a moving particle are in equilibrium, (e.g. when a spherical object reaches terminal velocity (neglecting increased air resistance as it gets closer to the ground)) then the particle will be moving at a velocity, that is not 0, yet the velocity will remain constant, and the body will not accelerate or decelerate in any direction, and thus the acceleration is 0.
Pascal's law (pressure exerted anywhere in a confined incompressible fluid is transmitted equally in all directions throughout the fluid such that the pressure variations (initial differences) remain the same)... and one common application would be a hydraulic lift (such as those used in garages to raise cars off the ground for inspection).
Assuming your cylinder is fixed and has something like a piston allowing for potential movement, the volume will remain the same. The gas will become less densed, as with pressure its more dense.
Assuming your cylinder is fixed and has something like a piston allowing for potential movement, the volume will remain the same. The gas will become less densed, as with pressure its more dense.
The piston of a gauge pressure rotating until its freely suspend because the weight of the piston is balanced by the centrifugal force. The centrifugal force is created by the rotation of the piston and is equal to the weight of the piston.
The function of grease is to remain in contact with and lubricate moving surfaces without leaking out under gravity or centrifugal action, or be squeezed out under pressure.
Stay, Stop, Pause, and Remain are all antonyms.
If the condenser fan becomes inoperative, the head pressure in the system would likely increase. This is due to an inefficient heat transfer process, causing the refrigerant to remain at a higher temperature, leading to higher pressure in the condenser. Additionally, the compressor may also overheat and trip the safety controls.
No, both the continental and oceanic plates are always moving. Moving slowly, but always moving.
"Constant pressure" means the pressure must not change.
Intended consequences in rural areas of people moving to cities may include reduced population pressure, improved access to services and resources for those who remain, and potential opportunities for economic diversification in the region.
it will be in the same direction in which it is moving. If it is not moving it will remain at rest
No. High pressure is pressure that is higher than an established normal pressure. The pressure may be rising, falling, or remain the same
Inertia