Want this question answered?
Be notified when an answer is posted
Chat with our AI personalities
An angle brace is a brace along an interior angle of a wooden frame, forming the hypotenuse and securing the two side pieces together.
A couple, a double, a pair, a brace, a span or a duet
Brace
side panel corrugations
The measurements of these two sets of vertical angles should add to 360. If two of the corresponding angles are 145, that means 290 degrees of that total 360 are taken up. 70 degrees is needed to make 360 (360 - 290 = 70). As the two acute angles must be equal, they are each 35 degrees.
Another word for brace is Support or hold
An angle brace is a brace along an interior angle of a wooden frame, forming the hypotenuse and securing the two side pieces together.
Support could be another word for brace or splint.
olyvia is a person with scoliosisher back is curved 49 degrees
Weaken, degenerate and enfeeble are antonyms for brace. Synonyms for brace include strengthen, support, bolster, prop, reinforce, refresh and invigorate.
A carpal tunnel brace helps by support and straightening the wrist to avoid pressure on the nerve.
Reinforce , brace , support , secure ,
Yes. Braces are used to group similar pieces of code in a C program
To properly install a cross brace for shelves, follow these steps: Measure and mark the placement of the cross brace on the wall and shelf. Use a level to ensure the brace is straight. Drill pilot holes into the wall and shelf. Attach the brace using screws or brackets. Test the stability of the shelf by applying pressure. This will help ensure that the cross brace provides the necessary stability and support for your shelves.
To properly install a 45-degree wood brace for added support in your project, follow these steps: Measure and mark the location where the brace will be installed. Cut the wood brace to the appropriate length at a 45-degree angle. Drill pilot holes in both the brace and the surface it will be attached to. Secure the brace in place using screws or nails, making sure it is flush against the surface. Double-check the alignment and stability of the brace before continuing with your project.
A brace map is a thinking map that classifys and breaks down certain topics into smaller pieces so that you can understand the topic more. Hope this helps! :/
If you're taling about a support or a brace, then it's stays