0
The depth of footings for a 3-meter by 2-meter extension typically depends on local building codes, soil conditions, and the load of the structure. Generally, footings should be placed below the frost line, which can range from 0.5 to 1.5 meters in many areas. A common depth for residential footings is around 1 meter, but it's essential to consult a structural engineer or local building authority for specific requirements based on your location.
What else can I help you with?
How many square feet is 1 square metre?
1 mtr = 100 cm 2.54 cm = 1 inch 12 inch = 1 ft. so, 1 mtr = 100/2.54 inch = 100/(2.54*12) ft. 1 mtr = 3.28 ft. so 1 sq. mtr = (3.28) ^ 2 sq. ft. = 10.76 sq. ft.
5.2 meters equals how many feet?
1 mtr = 3.28 feet, therefore 5.2 mtr = (5.2 * 3.28) feet = 17.056 feet Direct Conversion Formula 2 m* 1 ft 0.3048 m = 6.56167979 ft
How far is 10 Km?
About 2 hours walk 10,000 mtr 10936.133 yds 32808.399 ft 6.2137 miles
Want to know 100x100 x 8mm thk ms angle weight per meter?
Weight of MS Angle = (2*W-T)*T*L*7840 kg (All units are in MKS) Where, S = Width of any side in mtr T = Thickness of the angle in mtr. L = Length of the angle in mtr. 7840 is the density of MS in kg / m3. w=(2*.1-.008)*.008*1*7840 =(.2-.008)*62.72 =(.192)*62.72 =12.04 kg/mr
What does 24 inches equal?
0.609 mtr 2 feet 60.9 cm 0.666 yds 0.00061 km 0.00038 miles 0.00033 Nm 0.358 smoots
How much concrete do you need for footings 28foot by 2foot by3 foot?
To calculate the volume of concrete needed for footings that are 28 feet long, 2 feet wide, and 3 feet deep, use the formula for volume: length × width × depth. This results in a volume of 28 ft × 2 ft × 3 ft = 168 cubic feet. Therefore, you will need 168 cubic feet of concrete for the footings.
How much concrete is needed for a 10x28 patio?
One yard of concrete will cover approximately 90 square feet at a depth of 3-1/2". At an even 3-1/2", you will need just over 3 yards. This does not allow for any footings, turndowns, or a thicker slab.
How many square feet is 1 square metre?
1 mtr = 100 cm 2.54 cm = 1 inch 12 inch = 1 ft. so, 1 mtr = 100/2.54 inch = 100/(2.54*12) ft. 1 mtr = 3.28 ft. so 1 sq. mtr = (3.28) ^ 2 sq. ft. = 10.76 sq. ft.
How many mm in 1 sq mtr?
'mm' millimetres is a measure of length. 1 sq. mtr' is a measure of area. However, there are 1000 mm in 1 metre. So in 1 m^2 there are 1000mm X 1000 mm = 1,000,000 mm^2
5.2 meters equals how many feet?
1 mtr = 3.28 feet, therefore 5.2 mtr = (5.2 * 3.28) feet = 17.056 feet Direct Conversion Formula 2 m* 1 ft 0.3048 m = 6.56167979 ft
How far is 10 Km?
About 2 hours walk 10,000 mtr 10936.133 yds 32808.399 ft 6.2137 miles
Want to know 100x100 x 8mm thk ms angle weight per meter?
Weight of MS Angle = (2*W-T)*T*L*7840 kg (All units are in MKS) Where, S = Width of any side in mtr T = Thickness of the angle in mtr. L = Length of the angle in mtr. 7840 is the density of MS in kg / m3. w=(2*.1-.008)*.008*1*7840 =(.2-.008)*62.72 =(.192)*62.72 =12.04 kg/mr
What is the frost depth for Portsmouth VA?
The frost depth in Portsmouth, VA, typically ranges from 2 to 4 inches. However, it can vary based on specific weather conditions and soil types. It's important to consult local weather reports or agricultural extension services for the most accurate and current information.
How do you calculate surface area of a duct?
Dimension is : W * D* L IN MTR AREA SQ.MTR= (W+D) * 2 * L
What wind measurement is considered smooth water with small waves?
Small waves, up to 0.1 mtr are present in a force 2 wind.
How deep should the footings be for a totem pole in relation to its height?
The usual formula is this; for every foot above ground you put 1/2 foot in the ground.
What are the release dates for Chicagolicious - 2012 Immaculate Extension 2-14?
Chicagolicious - 2012 Immaculate Extension 2-14 was released on: USA: November 2012
