answersLogoWhite

0


Want this question answered?

Be notified when an answer is posted

Add your answer:

Earn +20 pts
Q: What distance should there be between a electrical meter base and an window?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Continue Learning about Math & Arithmetic

How do you measure angles for 4 by 4 braces for a bay window?

total distance divided by 1/4


Relationship between the maximum window size and the sequence number in Go-Back -N -Protocol?

maximum window size is the difference between highest available sequence number and send_base, knowing that send_base is the sequence number of sent and not yet acknowledged packet. window size= highest available sequence number-send_base=N. note that in GBN window cannot contains already acknowledged packet.


What measurement is used to measure the width of a window?

Windows are measured in the usual units of the country, whether metric (millimetres or metres) or imperial (feet and inches). The part of the window that is being measured needs to be specified. It could be: * the rough opening - the width of the hole in the wall into which the window will be fitted * the frame size - the width between outer parts of the window frame * the inside reveal to inside reveal width- the width between the timber trim around the window on the inside of the wall * the daylight opening - the unobscured glass width * the sash dimension - the dimension of the opening part of the frame All these measurements have different uses and by, for example specifying only the rough opening width, the exact type of window frame does not need to be specified.


Mullion is horizontal part or vertical part?

mullion - a nonstructural vertical strip between the casements or panes of a window (or the panels of a screen)


What is command window in matlab?

command window is a window in matlab environment, role of command window is that it shows output of some particular programme other than graph.

Related questions

How far should electrical service be from a window?

Are you asking about home electrical service? sevrice entrance cables need to be three feet away from a window


What is the distance between the car and drive through window?

Depends on how close you get. You control the distance.


What is the minimum distance allowed between basement window and main panel?

There is no code regulation regarding this scenario.


Distance between doors and exhaust tip?

federal law 18 inches past the furthest opening window


Exterior electrical service wires should be at least 3 feet away from?

Exterior electrical service wires should be at least 10 feet away from swimming pools to prevent any potential hazard.


How do you remove a window winder from a polo?

Between the window winder and door card there should be a plastic ring about 8mm wide. Push this ring away from the end of the window winder. The windes should now slide off


Why do the power window works for the passenger right and left rear window but not the driver window?

each time the driver's door is opened and closed the electrical harness between the door and the door pillar is flexed, often this causes a break in the wiring, make shure there is power and no broken wires.


How far should exterior electrical wires be from windows?

Exterior electrical wires should be a minimum of 3 feet away from windows to prevent potential hazards like accidental contact, electrical shock, and interference with window operations. It is also recommended to consult local building codes for specific guidelines regarding wire placement near windows.


How do you unstick a window from the inside?

Run a putty knife down both sides of the window then gently pry on the top between the two windows this should free the window so you can open and close it with no problem.


How do you replace broken window lift cable of electrical window in ford focus?

need diagram of focus electric windows 1999


What is the correct light switch distance from a window?

In the United States, I am unaware of any minimum distance required from a window. There may be a local code where you live or work that establishes a requirement.


Why the double-glazing window should not have a vacuum between the sheets of glass?

because vacuum will make the glass collapse