Want this question answered?
When surface datums are shown on extension lines, they are offset from dimension line arrows. Axis datums and center plane datums, on the other hand, can align with the dimension line's arrowheads.
IncorrectThere is nothing in the above Statement of Conditions that indicate the orientation of the Line L to the plane E.Therefore: there are two possible solutions.If the Line is parallel to the plane they never intersect.If it is not parallel then the line would intersect at only one point.
Line segment
a line with arrows on each end. it must have points in between the two arrows
Draw R. T and Y is a straight line with a line drawn through it. Put arrows on that line. Draw a large parallelogram around that and label it with a capital italics W.
A cutting plane line consists of a thick line shown through an area adjacent to the visible "cut" to clarify what is seen inside an object. Connected to the end of the line are two perpendicular lines with arrows showing the direction of view.
In Mathematics it may indicate parallel lines. In Chemistry it may indicate a reversible reaction.
ambot
a strait line with no points or arrows
Draw endpoints or arrows if the question specifies.
Because a line goes on forever, and the arrows indicate the same
A buttock line is a horizontal line on a ship's hull that represents the widest point of the vessel's rear section. It is important in ship design and construction as it helps determine the ship's stability, buoyancy, and overall performance in water.
When surface datums are shown on extension lines, they are offset from dimension line arrows. Axis datums and center plane datums, on the other hand, can align with the dimension line's arrowheads.
Coronal plane is a medical term. It is an imaginary line that slices the body in half cutting the body into front and back halves.
The arrows at the ends of a number line indicate that the line extends forever in both directions (i.e. towards positive infinity and negative infinity)...since there is no largest or smallest real number.
IncorrectThere is nothing in the above Statement of Conditions that indicate the orientation of the Line L to the plane E.Therefore: there are two possible solutions.If the Line is parallel to the plane they never intersect.If it is not parallel then the line would intersect at only one point.
Line segment