answersLogoWhite

0


Want this question answered?

Be notified when an answer is posted

Add your answer:

Earn +20 pts
Q: What does .8 inch look like on ruler?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

What does .35 inch look like on a ruler?

On a standard ruler, .35 inches would be located between the 1/4 inch mark and the 3/8 inch mark. It would be closer to the 1/4 inch mark, but not quite reaching the 3/8 inch mark. .35 inches is equivalent to 9 millimeters, so it would be slightly less than halfway between the 1/4 inch and 3/8 inch marks on the ruler.


How much is 0.83 on a ruler?

0.83 on a ruler would typically be between the 3/4 inch mark and the 7/8 inch mark.


What does 0.66 equal to on a ruler?

0.66 on a ruler represents 0.66 inches or 66 hundredths of an inch. It would fall between the 5/8 inch mark and the 11/16 inch mark on a standard ruler.


Where is 7.9 inches on ruler?

On a standard ruler, 7.9 inches would fall between the 7-inch mark and the 8-inch mark. Each inch on a ruler is divided into 16 equal parts, so 0.9 inches would be just slightly before the 1-inch mark after the 7-inch mark. To locate 7.9 inches precisely, you would count 7 full inches and then estimate just under a tenth of an inch beyond the 7-inch mark.


Can you show size of 8 mm mass?

An 8 mm mass is roughly one third of an inch. If you look at a ruler, this will give you a good idea of the size of such a mass. There are 2.54 cm or 25.4 mm in one inch. Therefore, 8 mm is just shy of 1/3 inch.


Where is 3.875 on a 12 inch ruler?

3.875 is the same as 3 and 7/8 inches on a ruler


Where on a ruler is an eighth of an inch?

1/8 = 2/16 = 4/32 = 8/64


What does 3.60 inches look like on a ruler?

It's between 9/16 and 5/8


What does 9.44 inches look like on a ruler?

You cannot see 9.44 inches on a ruler. The inches are often - though not always - marked in tenths. 9 inches will be shown on the ruler. From there move four small units towards the 10 inch mark. That is 9.4 inches away from the 0. Slightly less than half a mark further along is 9.44 inches.


Where is one-third of an inch on a ruler?

It's almost exactly 11/32" (a little under 3/8"). There is no one-third of an inch on the ruler; only halves, quarters, eighths, and sixteenths. One-third of an inch is about .85 centimeters.


How do you find 2.125 on a ruler?

To find 2.125 on a ruler, you first locate the whole number 2, which represents 2 inches. Each inch on a standard ruler is divided into 16 equal parts, so you then need to count 8 additional divisions beyond the 2-inch mark to reach 2.125. This is because 0.125 is equal to 1/8 of an inch, and 8 divisions out of the 16 represent this fraction on the ruler.


What do the lines on a inch ruler mean?

They denote different fractions of the inch. A good engineers ruler will have 64 ths, 32 nds 16 ths and 8 ths at least.