Birds attacking and gouging out the eyes
an arc is a segment of a circle. If the arc subtends a full angle of 360 degrees, then the arc is a circle; but this is a special case of an arc.
Arc measure is the number of radians. Two similar arcs could have the same arc measure. Arc length is particular to the individual arc. One must consider the radius of the arc in question then multiply the arc measure (in radians) times the radius to get the length.
major arc
arc homophone is ark
entah...
Any electrode holder that will accommodate the size of rod can be used. Twin Carbon Arc Welding requires a specific holder. Air Carbon Arc Gouging requires a special holder that also supplies a stream of air.
Any welding supply carries or can order for you, air arc carbon rods. They are the same that is used for air carbon arc gouging. Carbons are produced in two shapes, flat and round and various sizes. You would want the round ones.
Yes, price gouging creates a deadweight loss.
nope
Gouging is the process of removing unwanted materials.It is done by means of material is locally heated and molten metal is ejected out or blow up.
Gouging is a process where an arc is established between a carbon rod and the metal to be gouged and the metal is melted. A steady flow of air is blown into that molten pool removing the molten metal. Increasing the amperage or slowing down the travel speed allows a deeper gouge. Speeding up the travel speed or decreasing the amperage removes less metal. Copper coated carbon rods are used and are available in different diameters and shapes.
There are two types of gouging. First is with oxy-fuel. A special tip is used in the cutting torch that lets you direct the flame almost parallel to the work. A low pressure setting on the oxygen is directed thru the center of the tip. As the preheat flames melt the surface the operater depresses the cutting lever and the oxygen combines with the molten metal and is blown out creating a gouge as you proceed across the metal. The second requires a special torch and electrodes and is called carbon air arc gouging. High amperage settings allow you to establish an arc between the copper coated carbon electrodes and the metal. This melts the metal while a continous flow of high pressure air blows the molten metal out and a gouge is created as you move across the surface. In both instances the slower you move across the metal the deeper the gouge.
sudden increase in demand.
I would think so maybe but whatever
Price gouging prevents poor people that need a good from purchasing it, while encouraging hoarding by wealthy customers who don't actually need what they're buying.
Price Gouging